[PATCH 06/10] arm64: dts: ti: k3-am62: MDIO pinmux should belong to the MDIO node

[Andrew Davis]

Although usually integrated as a child of an Ethernet controller, MDIO
IP has an independent pinout. This pinout should be controlled by
the MDIO node (so if it was to be disabled for instance, the pinmux
state would reflect that).

Move the MDIO pins pinmux to the MIDO nodes.

Signed-off-by: Andrew Davis <afd at ti.com>
---
 arch/arm64/boot/dts/ti/k3-am625-sk.dts | 6 ++++--
 1 file changed, 4 insertions(+), 2 deletions(-)

diff --git a/arch/arm64/boot/dts/ti/k3-am625-sk.dts b/arch/arm64/boot/dts/ti/k3-am625-sk.dts
index 197d329a6082..318ec805ff54 100644
--- a/arch/arm64/boot/dts/ti/k3-am625-sk.dts
+++ b/arch/arm64/boot/dts/ti/k3-am625-sk.dts
@@ -353,8 +353,7 @@ &sdhci1 {
 
 &cpsw3g {
 	pinctrl-names = "default";
-	pinctrl-0 = <&main_mdio1_pins_default
-		     &main_rgmii1_pins_default
+	pinctrl-0 = <&main_rgmii1_pins_default
 		     &main_rgmii2_pins_default>;
 };
 
@@ -369,6 +368,9 @@ &cpsw_port2 {
 };
 
 &cpsw3g_mdio {
+	pinctrl-names = "default";
+	pinctrl-0 = <&main_mdio1_pins_default>;
+
 	cpsw3g_phy0: ethernet-phy at 0 {
 		reg = <0>;
 		ti,rx-internal-delay = <DP83867_RGMIIDCTL_2_00_NS>;
-- 
2.37.3