[PATCH 1/2] Revert "pinctrl: pinctrl-zynqmp: Add support for output-enable and bias-high-impedance"

[Sai Krishna Potthuri]

This reverts commit ad2bea79ef0144043721d4893eef719c907e2e63.

On systems with older PMUFW (Xilinx ZynqMP Platform Management Firmware)
using these pinctrl properties can cause system hang because there is
missing feature autodetection.
When this feature is implemented in the PMUFW, support for these two
properties should bring back.

Signed-off-by: Sai Krishna Potthuri <sai.krishna.potthuri at amd.com>
---
 drivers/pinctrl/pinctrl-zynqmp.c | 9 ---------
 1 file changed, 9 deletions(-)

diff --git a/drivers/pinctrl/pinctrl-zynqmp.c b/drivers/pinctrl/pinctrl-zynqmp.c
index 7d2fbf8a02cd..c98f35ad8921 100644
--- a/drivers/pinctrl/pinctrl-zynqmp.c
+++ b/drivers/pinctrl/pinctrl-zynqmp.c
@@ -412,10 +412,6 @@ static int zynqmp_pinconf_cfg_set(struct pinctrl_dev *pctldev,
 
 			break;
 		case PIN_CONFIG_BIAS_HIGH_IMPEDANCE:
-			param = PM_PINCTRL_CONFIG_TRI_STATE;
-			arg = PM_PINCTRL_TRI_STATE_ENABLE;
-			ret = zynqmp_pm_pinctrl_set_config(pin, param, arg);
-			break;
 		case PIN_CONFIG_MODE_LOW_POWER:
 			/*
 			 * These cases are mentioned in dts but configurable
@@ -424,11 +420,6 @@ static int zynqmp_pinconf_cfg_set(struct pinctrl_dev *pctldev,
 			 */
 			ret = 0;
 			break;
-		case PIN_CONFIG_OUTPUT_ENABLE:
-			param = PM_PINCTRL_CONFIG_TRI_STATE;
-			arg = PM_PINCTRL_TRI_STATE_DISABLE;
-			ret = zynqmp_pm_pinctrl_set_config(pin, param, arg);
-			break;
 		default:
 			dev_warn(pctldev->dev,
 				 "unsupported configuration parameter '%u'\n",
-- 
2.17.1