[PATCH v3 00/13] Add support for the Hardkernel ODROID-M1 board

[Dan Johansen]

Trying to apply the patchset, but patch 3 does not seem to apply on top 
of patch 2 for me.

We do patch in other rk3568 boards, which is messing up the Makefile 
patching, so I needed to redo patch 2 to fit.

So it might an error on my part.

Den 15.10.2022 kl. 20.47 skrev Aurelien Jarno:
> On 2022-10-08 15:53, Aurelien Jarno wrote:
>> On 2022-10-08 14:11, Dan Johansen wrote:
>>> Den 30.09.2022 kl. 07.12 skrev Aurelien Jarno:
>>>> On the ODROID forum, Dongjin Kim said he is not planning to submit a new
>>>> version of the patchset adding support for the Hardkernel ODROID-M1
>>>> board. I therefore decided to address the issues reported during the
>>>> initial review, and I also did some small fixes either because some
>>>> things changed in the meantime on the kernel side or because I noticed
>>>> some warning or issues when using the hardware.
>>>>
>>>> I continued writing some additional patches to complete the ODROID M1
>>>> DTS to almost fully support the hardware, the drivers being already
>>>> present in the kernel.
>>>>
>>>> This new version includes feedback from the linux-rockchip mailing list
>>>> and from the Odroid forum.
>>>>
>>>> Changes since v2:
>>>> * Renamed "Rockchip RK3568 Hardkernel ODROID-M1" into "Hardkernel Odroid
>>>>     M1" and fix the sorting.
>>>> * Fix sorting of arch/arm64/boot/dts/rockchip/Makefile
>>>> * Collected Acked-by and Tested-by
>>> Even though I added my Tested-by to this series, it seems I didn't test it
>>> on eMMC.
>>>
>>> This fails to boot for me on eMMC, but works on SD card and NVMe.
>> Thanks for the feedback. I do not have an eMMC, so this the only part
>> from the patchset that I haven't been able to test.
>>
>> First of all, which version have you tested? The v2 includes fixes for
>> the eMMC, there was a conflict with the NOR flash. If the problem is
>> still there in the v2, could you please send the boot log or the error
>> message?
> Sorry I meant v3 above. Anyway in the meantime I have bought an eMMC,
> and I confirm that:
> - it does no work with the v2 due to a conflict with the NOR flash
>    driver
> - it does work with the v3
>
> Therefore can you please retry with the v3?
>
> Thanks
> Aurelien
>
-- 
Kind regards
*Dan Johansen*
Project lead of the *Manjaro ARM* project
Manjaro-ARM <https://manjaro.org>