[PATCH v2 06/10] ARM: dts: stm32: enable USB HS phys on stm32mp135f-dk

[Fabrice Gasnier]

From: Amelie Delaunay <amelie.delaunay at foss.st.com>

USBPHYC manages the two USB High-Speed phys. port0 is used by USBH and
port1 is used by USBOTG.
Enable and tune both PHYs on stm32mp135f-dk.

Signed-off-by: Amelie Delaunay <amelie.delaunay at foss.st.com>
Signed-off-by: Fabrice Gasnier <fabrice.gasnier at foss.st.com>
---
 arch/arm/boot/dts/stm32mp135f-dk.dts | 32 ++++++++++++++++++++++++++++
 1 file changed, 32 insertions(+)

diff --git a/arch/arm/boot/dts/stm32mp135f-dk.dts b/arch/arm/boot/dts/stm32mp135f-dk.dts
index 291f05a958fd..af87fb36eabc 100644
--- a/arch/arm/boot/dts/stm32mp135f-dk.dts
+++ b/arch/arm/boot/dts/stm32mp135f-dk.dts
@@ -144,3 +144,35 @@ &uart4 {
 	pinctrl-0 = <&uart4_pins_a>;
 	status = "okay";
 };
+
+&usbphyc {
+	status = "okay";
+};
+
+&usbphyc_port0 {
+	phy-supply = <&vdd_usb>;
+	st,current-boost-microamp = <1000>;
+	st,decrease-hs-slew-rate;
+	st,tune-hs-dc-level = <2>;
+	st,enable-hs-rftime-reduction;
+	st,trim-hs-current = <11>;
+	st,trim-hs-impedance = <2>;
+	st,tune-squelch-level = <1>;
+	st,enable-hs-rx-gain-eq;
+	st,no-hs-ftime-ctrl;
+	st,no-lsfs-sc;
+};
+
+&usbphyc_port1 {
+	phy-supply = <&vdd_usb>;
+	st,current-boost-microamp = <1000>;
+	st,decrease-hs-slew-rate;
+	st,tune-hs-dc-level = <2>;
+	st,enable-hs-rftime-reduction;
+	st,trim-hs-current = <11>;
+	st,trim-hs-impedance = <2>;
+	st,tune-squelch-level = <1>;
+	st,enable-hs-rx-gain-eq;
+	st,no-hs-ftime-ctrl;
+	st,no-lsfs-sc;
+};
-- 
2.25.1