[PATCH v3 00/13] Add support for the Hardkernel ODROID-M1 board

[Dan Johansen]

Den 30.09.2022 kl. 07.12 skrev Aurelien Jarno:
> On the ODROID forum, Dongjin Kim said he is not planning to submit a new
> version of the patchset adding support for the Hardkernel ODROID-M1
> board. I therefore decided to address the issues reported during the
> initial review, and I also did some small fixes either because some
> things changed in the meantime on the kernel side or because I noticed
> some warning or issues when using the hardware.
>
> I continued writing some additional patches to complete the ODROID M1
> DTS to almost fully support the hardware, the drivers being already
> present in the kernel.
>
> This new version includes feedback from the linux-rockchip mailing list
> and from the Odroid forum.
>
> Changes since v2:
> * Renamed "Rockchip RK3568 Hardkernel ODROID-M1" into "Hardkernel Odroid
>    M1" and fix the sorting.
> * Fix sorting of arch/arm64/boot/dts/rockchip/Makefile
> * Collected Acked-by and Tested-by

Even though I added my Tested-by to this series, it seems I didn't test 
it on eMMC.

This fails to boot for me on eMMC, but works on SD card and NVMe.

Sorry about that.

> * Switched the NOR flash to dual I/O from quad I/O to solve a pin
>    conflicts with the EMMC.
> * Added a comment about the pull-up on the IR receiver GPIO
>
> Changes since v1 (patches 1 & 2):
> * Added Acked-by to the first patch
> * Fixed indentation
> * Removed unneeded labels
> * Renamed labels to not use underscore
> * Renamed regulator nodes
> * Added -pin to pinctrl bindings
> * Changed GPU related regulators to always on (see 2cda380102ff)
> * Added phy-supply to gmac0
> * Added supplies to sdhci
> * Changed SD card speed to SDR50 from SDR104 (see 1ea90b2d293f)
> * Fixed power LED polarity and set the default-state to "keep"
>
> Aurelien Jarno (11):
>    arm64: dts: rockchip: add thermal support to ODROID-M1
>    arm64: dts: rockchip: Add NOR flash to ODROID-M1
>    arm64: dts: rockchip: Add analog audio on ODROID-M1
>    arm64: dts: rockchip: Enable vop2 and hdmi tx on ODROID-M1
>    arm64: dts: rockchip: Enable HDMI audio on ODROID-M1.
>    arm64: dts: rockchip: Enable the GPU on ODROID-M1
>    arm64: dts: rockchip: Enable the USB 2.0 ports on ODROID-M1
>    arm64: dts: rockchip: Enable the USB 3.0 ports on ODROID-M1
>    arm64: dts: rockchip: Add SATA support to ODROID-M1
>    arm64: dts: rockchip: Add PCIEe v3 nodes to ODROID-M1
>    arm64: dts: rockchip: Add IR receiver node to ODROID-M1
>
> Dongjin Kim (2):
>    dt-bindings: rockchip: Add Hardkernel ODROID-M1 board
>    arm64: dts: rockchip: Add Hardkernel ODROID-M1 board
>
>   .../devicetree/bindings/arm/rockchip.yaml     |   5 +
>   arch/arm64/boot/dts/rockchip/Makefile         |   1 +
>   .../boot/dts/rockchip/rk3568-odroid-m1.dts    | 744 ++++++++++++++++++
>   3 files changed, 750 insertions(+)
>   create mode 100644 arch/arm64/boot/dts/rockchip/rk3568-odroid-m1.dts
>
-- 
Kind regards
*Dan Johansen*
Project lead of the *Manjaro ARM* project
Manjaro-ARM <https://manjaro.org>