[PATCH 5.10 045/162] ARM: dts: at91: sam9g20ek: enable udc vbus gpio pinctrl

[Greg Kroah-Hartman]

From: Michael Grzeschik <m.grzeschik at pengutronix.de>

[ Upstream commit 40a2226e8bfacb79dd154dea68febeead9d847e9 ]

We set the PIOC to GPIO mode. This way the pin becomes an
input signal will be usable by the controller. Without
this change the udc on the 9g20ek does not work.

Cc: nicolas.ferre at microchip.com
Cc: ludovic.desroches at microchip.com
Cc: alexandre.belloni at bootlin.com
Cc: linux-arm-kernel at lists.infradead.org
Cc: kernel at pengutronix.de
Fixes: 5cb4e73575e3 ("ARM: at91: add at91sam9g20ek boards dt support")
Signed-off-by: Michael Grzeschik <m.grzeschik at pengutronix.de>
Signed-off-by: Claudiu Beznea <claudiu.beznea at microchip.com>
Link: https://lore.kernel.org/r/20221114185923.1023249-3-m.grzeschik@pengutronix.de
Signed-off-by: Sasha Levin <sashal at kernel.org>
---
 arch/arm/boot/dts/at91sam9g20ek_common.dtsi | 9 +++++++++
 1 file changed, 9 insertions(+)

diff --git a/arch/arm/boot/dts/at91sam9g20ek_common.dtsi b/arch/arm/boot/dts/at91sam9g20ek_common.dtsi
index ca03685f0f08..4783e657b4cb 100644
--- a/arch/arm/boot/dts/at91sam9g20ek_common.dtsi
+++ b/arch/arm/boot/dts/at91sam9g20ek_common.dtsi
@@ -39,6 +39,13 @@ pinctrl_pck0_as_mck: pck0_as_mck {
 
 				};
 
+				usb1 {
+					pinctrl_usb1_vbus_gpio: usb1_vbus_gpio {
+						atmel,pins =
+							<AT91_PIOC 5 AT91_PERIPH_GPIO AT91_PINCTRL_DEGLITCH>;	/* PC5 GPIO */
+					};
+				};
+
 				mmc0_slot1 {
 					pinctrl_board_mmc0_slot1: mmc0_slot1-board {
 						atmel,pins =
@@ -84,6 +91,8 @@ macb0: ethernet at fffc4000 {
 			};
 
 			usb1: gadget at fffa4000 {
+				pinctrl-0 = <&pinctrl_usb1_vbus_gpio>;
+				pinctrl-names = "default";
 				atmel,vbus-gpio = <&pioC 5 GPIO_ACTIVE_HIGH>;
 				status = "okay";
 			};
-- 
2.35.1