[PATCH v5 3/4] cpufreq: apple-soc: Add new driver to control Apple SoC CPU P-states

[Viresh Kumar]

On 28-11-22, 23:29, Hector Martin wrote:
> This driver implements CPU frequency scaling for Apple Silicon SoCs,
> including M1 (t8103), M1 Max/Pro/Ultra (t600x), and M2 (t8112).
> 
> Each CPU cluster has its own register set, and frequency management is
> fully automated by the hardware; the driver only has to write one
> register. There is boost frequency support, but the hardware will only
> allow their use if only a subset of cores in a cluster are in
> non-deep-idle. Since we don't support deep idle yet, these frequencies
> are not achievable, but the driver supports them. They will remain
> disabled in the device tree until deep idle is implemented, to avoid
> confusing users.
> 
> This driver does not yet implement the memory controller performance
> state tuning that usually accompanies higher CPU p-states. This will be
> done in a future patch.
> 
> Acked-by: Marc Zyngier <maz at kernel.org>
> Signed-off-by: Hector Martin <marcan at marcan.st>
> ---
>  drivers/cpufreq/Kconfig.arm          |   9 +
>  drivers/cpufreq/Makefile             |   1 +
>  drivers/cpufreq/apple-soc-cpufreq.c  | 352 +++++++++++++++++++++++++++
>  drivers/cpufreq/cpufreq-dt-platdev.c |   2 +
>  4 files changed, 364 insertions(+)
>  create mode 100644 drivers/cpufreq/apple-soc-cpufreq.c

Applied. Thanks.

-- 
viresh