[PATCH v2 12/12] riscv: defconfig: Enable the Allwinner D1 platform and drivers

Heiko Stübner heiko at sntech.de
Mon Nov 28 13:11:18 PST 2022


Am Samstag, 26. November 2022, 17:40:11 CET schrieb Conor Dooley:
> On Fri, Nov 25, 2022 at 05:46:56PM -0600, Samuel Holland wrote:
> > Now that several D1-based boards are supported, enable the platform in
> > our defconfig. Build in the drivers which are necessary to boot, such as
> > the pinctrl, MMC, RTC (which provides critical clocks), SPI (for flash),
> > and watchdog (which may be left enabled by the bootloader).
> 
> All of that looks good.
> 
> > Other common
> > onboard peripherals are enabled as modules.
> 
> This I am not sure about though. I'll leave that to Palmer since I'm
> pretty sure it was him that said it, but I thought the plan was only
> turning on stuff required to boot to a console & things that are
> generally useful rather than enabling modules for everyone's "random"
> drivers. Palmer?

Isn't the defconfig meant as a starting point to get working systems
with minimal config effort? At least that was always the way to go on arm
so far :-) .

So having boot-required drivers built-in with the rest enabled as modules
for supported boards will allow people to boot theirs without headaches.

Disabling unneeded drivers if you're starved for storage space in a special
project is always easier than hunting down all the drivers to enable for a
specific board. 


Heiko


> > Signed-off-by: Samuel Holland <samuel at sholland.org>
> > ---
> > 
> > (no changes since v1)
> > 
> >  arch/riscv/configs/defconfig | 23 ++++++++++++++++++++++-
> >  1 file changed, 22 insertions(+), 1 deletion(-)
> > 
> > diff --git a/arch/riscv/configs/defconfig b/arch/riscv/configs/defconfig
> > index 05fd5fcf24f9..8dfe0550c0e6 100644
> > --- a/arch/riscv/configs/defconfig
> > +++ b/arch/riscv/configs/defconfig
> > @@ -25,6 +25,7 @@ CONFIG_BLK_DEV_INITRD=y
> >  CONFIG_EXPERT=y
> >  # CONFIG_SYSFS_SYSCALL is not set
> >  CONFIG_PROFILING=y
> > +CONFIG_ARCH_SUNXI=y
> >  CONFIG_SOC_MICROCHIP_POLARFIRE=y
> >  CONFIG_SOC_SIFIVE=y
> >  CONFIG_SOC_STARFIVE=y
> > @@ -118,22 +119,31 @@ CONFIG_VIRTIO_NET=y
> >  CONFIG_MACB=y
> >  CONFIG_E1000E=y
> >  CONFIG_R8169=y
> > +CONFIG_STMMAC_ETH=m
> >  CONFIG_MICROSEMI_PHY=y
> >  CONFIG_INPUT_MOUSEDEV=y
> > +CONFIG_KEYBOARD_SUN4I_LRADC=m
> >  CONFIG_SERIAL_8250=y
> >  CONFIG_SERIAL_8250_CONSOLE=y
> > +CONFIG_SERIAL_8250_DW=y
> >  CONFIG_SERIAL_OF_PLATFORM=y
> >  CONFIG_VIRTIO_CONSOLE=y
> >  CONFIG_HW_RANDOM=y
> >  CONFIG_HW_RANDOM_VIRTIO=y
> > +CONFIG_I2C_MV64XXX=m
> >  CONFIG_SPI=y
> >  CONFIG_SPI_SIFIVE=y
> > +CONFIG_SPI_SUN6I=y
> >  # CONFIG_PTP_1588_CLOCK is not set
> > -CONFIG_GPIOLIB=y
> >  CONFIG_GPIO_SIFIVE=y
> > +CONFIG_WATCHDOG=y
> > +CONFIG_SUNXI_WATCHDOG=y
> > +CONFIG_REGULATOR=y
> > +CONFIG_REGULATOR_FIXED_VOLTAGE=y
> >  CONFIG_DRM=m
> >  CONFIG_DRM_RADEON=m
> >  CONFIG_DRM_NOUVEAU=m
> > +CONFIG_DRM_SUN4I=m
> >  CONFIG_DRM_VIRTIO_GPU=m
> >  CONFIG_FB=y
> >  CONFIG_FRAMEBUFFER_CONSOLE=y
> > @@ -146,19 +156,30 @@ CONFIG_USB_OHCI_HCD=y
> >  CONFIG_USB_OHCI_HCD_PLATFORM=y
> >  CONFIG_USB_STORAGE=y
> >  CONFIG_USB_UAS=y
> > +CONFIG_USB_MUSB_HDRC=m
> > +CONFIG_USB_MUSB_SUNXI=m
> > +CONFIG_NOP_USB_XCEIV=m
> >  CONFIG_MMC=y
> >  CONFIG_MMC_SDHCI=y
> >  CONFIG_MMC_SDHCI_PLTFM=y
> >  CONFIG_MMC_SDHCI_CADENCE=y
> >  CONFIG_MMC_SPI=y
> > +CONFIG_MMC_SUNXI=y
> >  CONFIG_RTC_CLASS=y
> > +CONFIG_RTC_DRV_SUN6I=y
> > +CONFIG_DMADEVICES=y
> > +CONFIG_DMA_SUN6I=m
> >  CONFIG_VIRTIO_PCI=y
> >  CONFIG_VIRTIO_BALLOON=y
> >  CONFIG_VIRTIO_INPUT=y
> >  CONFIG_VIRTIO_MMIO=y
> > +CONFIG_SUN8I_DE2_CCU=m
> > +CONFIG_SUN50I_IOMMU=y
> >  CONFIG_RPMSG_CHAR=y
> >  CONFIG_RPMSG_CTRL=y
> >  CONFIG_RPMSG_VIRTIO=y
> > +CONFIG_PHY_SUN4I_USB=m
> > +CONFIG_NVMEM_SUNXI_SID=y
> >  CONFIG_EXT4_FS=y
> >  CONFIG_EXT4_FS_POSIX_ACL=y
> >  CONFIG_EXT4_FS_SECURITY=y
> 







More information about the linux-arm-kernel mailing list