[PATCH 1/3] dt-bindings: mfd: da9062: Move IRQ to optional properties
Christoph Niedermaier
cniedermaier at dh-electronics.com
Tue Nov 22 01:58:31 PST 2022
Move IRQ to optional properties, because the MFD DA9061/62
is usable without IRQ. This makes the chip usable for designs
that don't have the IRQ pin connected.
Signed-off-by: Christoph Niedermaier <cniedermaier at dh-electronics.com>
---
Cc: Support Opensource <support.opensource at diasemi.com>
Cc: Adam Thomson <Adam.Thomson.Opensource at diasemi.com>
Cc: Lee Jones <lee at kernel.org>
Cc: Rob Herring <robh+dt at kernel.org>
Cc: Krzysztof Kozlowski <krzysztof.kozlowski+dt at linaro.org>
Cc: Marek Vasut <marex at denx.de>
Cc: kernel at dh-electronics.com
Cc: devicetree at vger.kernel.org
To: linux-kernel at vger.kernel.org
---
Documentation/devicetree/bindings/mfd/da9062.txt | 11 ++++++-----
1 file changed, 6 insertions(+), 5 deletions(-)
diff --git a/Documentation/devicetree/bindings/mfd/da9062.txt b/Documentation/devicetree/bindings/mfd/da9062.txt
index bab0d0e66cb3..fe580206e18d 100644
--- a/Documentation/devicetree/bindings/mfd/da9062.txt
+++ b/Documentation/devicetree/bindings/mfd/da9062.txt
@@ -33,11 +33,6 @@ Required properties:
"dlg,da9061" for DA9061
- reg : Specifies the I2C slave address (this defaults to 0x58 but it can be
modified to match the chip's OTP settings).
-- interrupts : IRQ line information.
-- interrupt-controller
-
-See Documentation/devicetree/bindings/interrupt-controller/interrupts.txt for
-further information on IRQ bindings.
Optional properties:
@@ -48,6 +43,12 @@ Optional properties:
See Documentation/devicetree/bindings/gpio/gpio.txt for further information on
GPIO bindings.
+- interrupts : IRQ line information.
+- interrupt-controller
+
+See Documentation/devicetree/bindings/interrupt-controller/interrupts.txt for
+further information on IRQ bindings.
+
Sub-nodes:
- regulators : This node defines the settings for the LDOs and BUCKs.
--
2.11.0
More information about the linux-arm-kernel
mailing list