[PATCH v13,2/3] drm: mediatek: Set dpi format in mmsys

Matthias Brugger matthias.bgg at gmail.com
Mon Nov 21 10:26:24 PST 2022



On 24/10/2022 04:04, xinlei.lee at mediatek.com wrote:
> From: Xinlei Lee <xinlei.lee at mediatek.com>
> 
> Dpi output needs to adjust the output format to dual edge for MT8186.
> 
> Co-developed-by: Jitao Shi <jitao.shi at mediatek.com>
> Signed-off-by: Jitao Shi <jitao.shi at mediatek.com>
> Signed-off-by: Xinlei Lee <xinlei.lee at mediatek.com>
> Reviewed-by: CK Hu <ck.hu at mediatek.com>
> Reviewed-by: AngeloGioacchino Del Regno <angelogioacchino.delregno at collabora.com>
> Reviewed-by: Nícolas F. R. A. Prado <nfraprado at collabora.com>

I realized that I took this patch by error. I'll drop it from my tree now.

Regards,
Matthias

> ---
>   drivers/gpu/drm/mediatek/mtk_dpi.c | 11 +++++++++++
>   1 file changed, 11 insertions(+)
> 
> diff --git a/drivers/gpu/drm/mediatek/mtk_dpi.c b/drivers/gpu/drm/mediatek/mtk_dpi.c
> index 630a4e301ef6..ad87ecddf58d 100644
> --- a/drivers/gpu/drm/mediatek/mtk_dpi.c
> +++ b/drivers/gpu/drm/mediatek/mtk_dpi.c
> @@ -15,6 +15,7 @@
>   #include <linux/of_graph.h>
>   #include <linux/pinctrl/consumer.h>
>   #include <linux/platform_device.h>
> +#include <linux/soc/mediatek/mtk-mmsys.h>
>   #include <linux/types.h>
>   
>   #include <video/videomode.h>
> @@ -30,6 +31,7 @@
>   #include "mtk_disp_drv.h"
>   #include "mtk_dpi_regs.h"
>   #include "mtk_drm_ddp_comp.h"
> +#include "mtk_drm_drv.h"
>   
>   enum mtk_dpi_out_bit_num {
>   	MTK_DPI_OUT_BIT_NUM_8BITS,
> @@ -67,6 +69,7 @@ struct mtk_dpi {
>   	struct drm_connector *connector;
>   	void __iomem *regs;
>   	struct device *dev;
> +	struct device *mmsys_dev;
>   	struct clk *engine_clk;
>   	struct clk *pixel_clk;
>   	struct clk *tvd_clk;
> @@ -135,6 +138,7 @@ struct mtk_dpi_yc_limit {
>    * @yuv422_en_bit: Enable bit of yuv422.
>    * @csc_enable_bit: Enable bit of CSC.
>    * @pixels_per_iter: Quantity of transferred pixels per iteration.
> + * @edge_cfg_in_mmsys: If the edge configuration for DPI's output needs to be set in MMSYS.
>    */
>   struct mtk_dpi_conf {
>   	unsigned int (*cal_factor)(int clock);
> @@ -153,6 +157,7 @@ struct mtk_dpi_conf {
>   	u32 yuv422_en_bit;
>   	u32 csc_enable_bit;
>   	u32 pixels_per_iter;
> +	bool edge_cfg_in_mmsys;
>   };
>   
>   static void mtk_dpi_mask(struct mtk_dpi *dpi, u32 offset, u32 val, u32 mask)
> @@ -449,8 +454,12 @@ static void mtk_dpi_dual_edge(struct mtk_dpi *dpi)
>   		mtk_dpi_mask(dpi, DPI_OUTPUT_SETTING,
>   			     dpi->output_fmt == MEDIA_BUS_FMT_RGB888_2X12_LE ?
>   			     EDGE_SEL : 0, EDGE_SEL);
> +		if (dpi->conf->edge_cfg_in_mmsys)
> +			mtk_mmsys_ddp_dpi_fmt_config(dpi->mmsys_dev, MTK_DPI_RGB888_DDR_CON);
>   	} else {
>   		mtk_dpi_mask(dpi, DPI_DDR_SETTING, DDR_EN | DDR_4PHASE, 0);
> +		if (dpi->conf->edge_cfg_in_mmsys)
> +			mtk_mmsys_ddp_dpi_fmt_config(dpi->mmsys_dev, MTK_DPI_RGB888_SDR_CON);
>   	}
>   }
>   
> @@ -778,8 +787,10 @@ static int mtk_dpi_bind(struct device *dev, struct device *master, void *data)
>   {
>   	struct mtk_dpi *dpi = dev_get_drvdata(dev);
>   	struct drm_device *drm_dev = data;
> +	struct mtk_drm_private *priv = drm_dev->dev_private;
>   	int ret;
>   
> +	dpi->mmsys_dev = priv->mmsys_dev;
>   	ret = drm_simple_encoder_init(drm_dev, &dpi->encoder,
>   				      DRM_MODE_ENCODER_TMDS);
>   	if (ret) {



More information about the linux-arm-kernel mailing list