[PATCH net] net: stmmac: Set MAC's flow control register to reflect current settings

[Russell King (Oracle)]

On Fri, Nov 18, 2022 at 03:20:51PM +0800, Goh, Wei Sheng wrote:
> diff --git a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
> index 8273e6a175c8..ab7f48f32f5b 100644
> --- a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
> +++ b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
> @@ -1061,8 +1061,16 @@ static void stmmac_mac_link_up(struct phylink_config *config,
>  		ctrl |= priv->hw->link.duplex;
>  
>  	/* Flow Control operation */
> -	if (tx_pause && rx_pause)
> -		stmmac_mac_flow_ctrl(priv, duplex);
> +	if (rx_pause && tx_pause)
> +		priv->flow_ctrl = FLOW_AUTO;
> +	else if (rx_pause && !tx_pause)
> +		priv->flow_ctrl = FLOW_RX;
> +	else if (!rx_pause && tx_pause)
> +		priv->flow_ctrl = FLOW_TX;
> +	else if (!rx_pause && !tx_pause)
> +		priv->flow_ctrl = FLOW_OFF;

Since "if (!rx_pause && !tx_pause)" will always be true at this point,
you can eliminate this needless last condition, which will make the code
a little more readable.

Thanks.

-- 
RMK's Patch system: https://www.armlinux.org.uk/developer/patches/
FTTP is here! 40Mbps down 10Mbps up. Decent connectivity at last!