[PATCH V6 11/12] arm64: dts: imx8m[m,q]-evk: change to use off-on-delay-us in regulator

Peng Fan (OSS) peng.fan at oss.nxp.com
Thu Nov 17 01:54:02 PST 2022


From: Haibo Chen <haibo.chen at nxp.com>

Some SD Card controller and power circuitry has increased capacitance,
so the usual toggling of regulator to power the card off and on
is insufficient.

According to SD spec, for sd card power reset operation, the sd card
supply voltage needs to be lower than 0.5v and keep over 1ms, otherwise,
next time power back the sd card supply voltage to 3.3v, sd card can't
support SD3.0 mode again.

This patch add the off-on-delay-us, make sure the sd power reset behavior
is align with the specification. Without this patch, when do quick system
suspend/resume test, some sd card can't work at SD3.0 mode after system
resume back.

Signed-off-by: Haibo Chen <haibo.chen at nxp.com>
Signed-off-by: Peng Fan <peng.fan at nxp.com>
Reviewed-by: Marco Felsch <m.felsch at pengutronix.de>
---
 arch/arm64/boot/dts/freescale/imx8mm-evk.dtsi | 1 +
 arch/arm64/boot/dts/freescale/imx8mq-evk.dts  | 1 +
 2 files changed, 2 insertions(+)

diff --git a/arch/arm64/boot/dts/freescale/imx8mm-evk.dtsi b/arch/arm64/boot/dts/freescale/imx8mm-evk.dtsi
index 6800d923aa7e..3f2b0ad51e18 100644
--- a/arch/arm64/boot/dts/freescale/imx8mm-evk.dtsi
+++ b/arch/arm64/boot/dts/freescale/imx8mm-evk.dtsi
@@ -56,6 +56,7 @@ reg_usdhc2_vmmc: regulator-usdhc2 {
 		regulator-min-microvolt = <3300000>;
 		regulator-max-microvolt = <3300000>;
 		gpio = <&gpio2 19 GPIO_ACTIVE_HIGH>;
+		off-on-delay-us = <20000>;
 		enable-active-high;
 	};
 
diff --git a/arch/arm64/boot/dts/freescale/imx8mq-evk.dts b/arch/arm64/boot/dts/freescale/imx8mq-evk.dts
index 2102e9b57697..78937910f403 100644
--- a/arch/arm64/boot/dts/freescale/imx8mq-evk.dts
+++ b/arch/arm64/boot/dts/freescale/imx8mq-evk.dts
@@ -46,6 +46,7 @@ reg_usdhc2_vmmc: regulator-vsd-3v3 {
 		regulator-min-microvolt = <3300000>;
 		regulator-max-microvolt = <3300000>;
 		gpio = <&gpio2 19 GPIO_ACTIVE_HIGH>;
+		off-on-delay-us = <20000>;
 		enable-active-high;
 	};
 
-- 
2.37.1




More information about the linux-arm-kernel mailing list