[PATCH] arm64: dts: ti: k3-j721s2: Fix the interrupt ranges property for main & wkup gpio intr

[Vaishnav Achath]

On 22/09/22 12:59, Keerthy wrote:
> The parent's input irq number is wrongly subtracted with 32 instead of
> using the exact numbers in:
> 
> https://software-dl.ti.com/tisci/esd/latest/5_soc_doc/j721s2/interrupt_cfg.html
> 
> The GPIO interrupts are not working because of that. The toggling works
> fine but interrupts are not firing. Fix the parent's input irq that
> specifies the base for parent irq.
> 
> Tested for MAIN_GPIO0_6 interrupt on the j721s2 EVM.
> 
> Fixes: b8545f9d3a542 ("arm64: dts: ti: Add initial support for J721S2 SoC")
> Signed-off-by: Keerthy <j-keerthy at ti.com>
> ---
>  arch/arm64/boot/dts/ti/k3-j721s2-main.dtsi       | 2 +-
>  arch/arm64/boot/dts/ti/k3-j721s2-mcu-wakeup.dtsi | 2 +-
>  2 files changed, 2 insertions(+), 2 deletions(-)
> 
> diff --git a/arch/arm64/boot/dts/ti/k3-j721s2-main.dtsi b/arch/arm64/boot/dts/ti/k3-j721s2-main.dtsi
> index 34e7d577ae13..c89f28235812 100644
> --- a/arch/arm64/boot/dts/ti/k3-j721s2-main.dtsi
> +++ b/arch/arm64/boot/dts/ti/k3-j721s2-main.dtsi
> @@ -60,7 +60,7 @@
>  		#interrupt-cells = <1>;
>  		ti,sci = <&sms>;
>  		ti,sci-dev-id = <148>;
> -		ti,interrupt-ranges = <8 360 56>;
> +		ti,interrupt-ranges = <8 392 56>;
>  	};
>  
>  	main_pmx0: pinctrl at 11c000 {
> diff --git a/arch/arm64/boot/dts/ti/k3-j721s2-mcu-wakeup.dtsi b/arch/arm64/boot/dts/ti/k3-j721s2-mcu-wakeup.dtsi
> index 4d1bfabd1313..f0644851602c 100644
> --- a/arch/arm64/boot/dts/ti/k3-j721s2-mcu-wakeup.dtsi
> +++ b/arch/arm64/boot/dts/ti/k3-j721s2-mcu-wakeup.dtsi
> @@ -65,7 +65,7 @@
>  		#interrupt-cells = <1>;
>  		ti,sci = <&sms>;
>  		ti,sci-dev-id = <125>;
> -		ti,interrupt-ranges = <16 928 16>;
> +		ti,interrupt-ranges = <16 960 16>;

Reviewed-by: Vaishnav Achath <vaishnav.a at ti.com>

>  	};
>  
>  	mcu_conf: syscon at 40f00000 {

-- 
Regards,
Vaishnav