[PATCH v2] spi: spi-imx: Fix spi_bus_clk if requested clock is higher than input clock

[Marc Kleine-Budde]

On 15.11.2022 17:26:53, Frieder Schrempf wrote:
> From: Frieder Schrempf <frieder.schrempf at kontron.de>
> 
> In case the requested bus clock is higher than the input clock, the correct
> dividers (pre = 0, post = 0) are returned from mx51_ecspi_clkdiv(), but
> *fres is left uninitialized and therefore contains an arbitrary value.
> 
> This causes trouble for the recently introduced PIO polling feature as the
> value in spi_imx->spi_bus_clk is used there to calculate for which
> transfers to enable PIO polling.
> 
> Fix this by setting *fres even if no clock dividers are in use.
> 
> This issue was observed on Kontron BL i.MX8MM with an SPI peripheral clock set
> to 50 MHz by default and a requested SPI bus clock of 80 MHz for the SPI NOR
> flash.
> 
> With the fix applied the debug message from mx51_ecspi_clkdiv() now prints the
> following:
> 
> spi_imx 30820000.spi: mx51_ecspi_clkdiv: fin: 50000000, fspi: 50000000,
> post: 0, pre: 0
> 
> Fixes: 07e759387788 ("spi: spi-imx: add PIO polling support")

The *fres parameter was introduced in:

| Fixes: 6fd8b8503a0d ("spi: spi-imx: Fix out-of-order CS/SCLK operation at low speeds")

The exiting code:

|	if (unlikely(fspi > fin))
|		return 0;

was not sufficient any more and should be fixed.

Marc

-- 
Pengutronix e.K.                 | Marc Kleine-Budde           |
Embedded Linux                   | https://www.pengutronix.de  |
Vertretung West/Dortmund         | Phone: +49-231-2826-924     |
Amtsgericht Hildesheim, HRA 2686 | Fax:   +49-5121-206917-5555 |
-------------- next part --------------
A non-text attachment was scrubbed...
Name: signature.asc
Type: application/pgp-signature
Size: 488 bytes
Desc: not available
URL: <http://lists.infradead.org/pipermail/linux-arm-kernel/attachments/20221115/0447c3a3/attachment-0001.sig>