[PATCH V5 11/12] arm64: dts: imx8m[m, q]-evk: change to use off-on-delay-us in regulator

[Marco Felsch]

On 22-11-15, Peng Fan (OSS) wrote:
> From: Haibo Chen <haibo.chen at nxp.com>
> 
> Some SD Card controller and power circuitry has increased capacitance,
> so the usual toggling of regulator to power the card off and on
> is insufficient.
> 
> According to SD spec, for sd card power reset operation, the sd card
> supply voltage needs to be lower than 0.5v and keep over 1ms, otherwise,
> next time power back the sd card supply voltage to 3.3v, sd card can't
> support SD3.0 mode again.
> 
> This patch add the off-on-delay-us, make sure the sd power reset behavior
> is align with the specification. Without this patch, when do quick system
> suspend/resume test, some sd card can't work at SD3.0 mode after system
> resume back.
> 
> Signed-off-by: Haibo Chen <haibo.chen at nxp.com>
> Signed-off-by: Peng Fan <peng.fan at nxp.com>

Reviewed-by: Marco Felsch <m.felsch at pengutronix.de>

> ---
>  arch/arm64/boot/dts/freescale/imx8mm-evk.dtsi | 1 +
>  arch/arm64/boot/dts/freescale/imx8mq-evk.dts  | 1 +
>  2 files changed, 2 insertions(+)
> 
> diff --git a/arch/arm64/boot/dts/freescale/imx8mm-evk.dtsi b/arch/arm64/boot/dts/freescale/imx8mm-evk.dtsi
> index 7d6317d95b13..f881494996a1 100644
> --- a/arch/arm64/boot/dts/freescale/imx8mm-evk.dtsi
> +++ b/arch/arm64/boot/dts/freescale/imx8mm-evk.dtsi
> @@ -56,6 +56,7 @@ reg_usdhc2_vmmc: regulator-usdhc2 {
>  		regulator-min-microvolt = <3300000>;
>  		regulator-max-microvolt = <3300000>;
>  		gpio = <&gpio2 19 GPIO_ACTIVE_HIGH>;
> +		off-on-delay-us = <20000>;
>  		enable-active-high;
>  	};
>  
> diff --git a/arch/arm64/boot/dts/freescale/imx8mq-evk.dts b/arch/arm64/boot/dts/freescale/imx8mq-evk.dts
> index 82387b9cb800..07d9fb2aacf8 100644
> --- a/arch/arm64/boot/dts/freescale/imx8mq-evk.dts
> +++ b/arch/arm64/boot/dts/freescale/imx8mq-evk.dts
> @@ -46,6 +46,7 @@ reg_usdhc2_vmmc: regulator-vsd-3v3 {
>  		regulator-min-microvolt = <3300000>;
>  		regulator-max-microvolt = <3300000>;
>  		gpio = <&gpio2 19 GPIO_ACTIVE_HIGH>;
> +		off-on-delay-us = <20000>;
>  		enable-active-high;
>  	};
>  
> -- 
> 2.37.1
> 
> 
>