[PATCH v2 3/3] dt-bindings: gpio: Add Nuvoton NPCM750 serial I/O expansion interface(SGPIO)

[Linus Walleij]

Hi Jim,

thanks for your patch!

On Tue, Nov 8, 2022 at 10:29 AM Jim Liu <jim.t90615 at gmail.com> wrote:
>
> NPCM750 include two SGPIO modules.
> Each module supports up to 64 input and 64 output pins.
> the output pin must be serial to parallel device(such as the hc595)
> the input in must be parallel to serial device(such as the hc165)
>
> Signed-off-by: Jim Liu <JJLIU0 at nuvoton.com>
> ---
> Changes for v2:
>    - modify description
(...)

This:

> +  GPIO pins can be programmed to support the following options
> +  - Support interrupt option for each input port and various interrupt
> +    sensitivity option (level-high, level-low, edge-high, edge-low)
> +  - Directly connected to APB bus and its shift clock is from APB bus clock
> +    divided by a programmable value.
> +  - nin_gpios is number of input GPIO lines
> +  - nout_gpios is number of output GPIO lines
> +  - ngpios is number of nin_gpios GPIO lines and nout_gpios GPIO lines.

Why does input/output have to be configured uniquely/static per system?

What is wrong with just using direction_input() and direction_output()
at runtime like everybody else?

> +        nin_gpios = <64>;
> +        nout_gpios = <64>;

Especially since in the example you just set them all to be both input
and output so they all depend on runtime direction configuration
anyway.

Yours,
Linus Walleij