[PATCH 2/4] net: stmmac: dwc-qos: Add FSD EQoS support

[Andrew Lunn]

> For FSD SoC, a mux switch is needed between internal and external clocks.
> By default after reset internal clock is used but for receiving packets
> properly, external clock is needed. Mux switch to external clock happens
> only when the external clock is present.


> +++ b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
> @@ -3831,6 +3831,9 @@ static int __stmmac_open(struct net_device *dev,
>  	netif_tx_start_all_queues(priv->dev);
>  	stmmac_enable_all_dma_irq(priv);
>  
> +	if (priv->plat->rxmux_setup)
> +		priv->plat->rxmux_setup(priv->plat->bsp_priv, true);
> +
>  	return 0;
>  
>  irq_error:
> @@ -3884,6 +3887,9 @@ static int stmmac_release(struct net_device *dev)
>  	struct stmmac_priv *priv = netdev_priv(dev);
>  	u32 chan;
>  
> +	if (priv->plat->rxmux_setup)
> +		priv->plat->rxmux_setup(priv->plat->bsp_priv, false);
> +

Is this the code which is deciding if the external clock is present? So when somebody called
'ip link set eth42 up'?

Where is the external clock coming from?

      Andrew