[PATCH v2 2/2] arm64: dts: ti: k3-am625-sk: mark MCU and WKUP watchdogs as reserved

[Nishanth Menon]

On 17:36-20221103, Andrew Davis wrote:
> On 11/3/22 4:47 PM, Nishanth Menon wrote:
> > On 19:14-20221103, Julien Panis wrote:
> > > MCU wdt is typically used by M4F.
> > > Wake up wdt is typically used by DM (R5) firmware.
> > > 
> > > Signed-off-by: Julien Panis <jpanis at baylibre.com>
> > > ---
> > >   arch/arm64/boot/dts/ti/k3-am625-sk.dts | 10 ++++++++++
> > >   1 file changed, 10 insertions(+)
> > > 
> > > diff --git a/arch/arm64/boot/dts/ti/k3-am625-sk.dts b/arch/arm64/boot/dts/ti/k3-am625-sk.dts
> > > index 93a5f0817efc..9ade591ef563 100644
> > > --- a/arch/arm64/boot/dts/ti/k3-am625-sk.dts
> > > +++ b/arch/arm64/boot/dts/ti/k3-am625-sk.dts
> > > @@ -503,6 +503,16 @@ &main_mcan0 {
> > >   	status = "disabled";
> > >   };
> > > +&mcu_rti0 {
> > > +	/* MCU RTI0 is used by M4F firmware */
> > > +	status = "reserved";
> > > +};
> > > +
> > > +&wkup_rti0 {
> > > +	/* WKUP RTI0 is used by DM firmware */
> > > +	status = "reserved";
> > > +};
> > > +
> > 
> > If this is the typical usage, should'nt we do this in soc.dtsi than
> > sprinkle this through various boards?
> > 
> > Andrew: ?
> 
> These are only "reserved" for certain firmware, you choose your RPROCs
> and firmware down at the bottom level in board DTs. So I'd say these
> statuses should be set at this same level here.
> 
> DM firmware might be the exception as it should always be present,
> but for M4F firmware, meh, leave it here.
> 

That makes sense.. Julien: Could you address this please?

-- 
Regards,
Nishanth Menon
Key (0xDDB5849D1736249D) / Fingerprint: F8A2 8693 54EB 8232 17A3  1A34 DDB5 849D 1736 249D