[PATCH 01/18] KVM: arm64: Always start with clearing SVE flag on load

[Mark Brown]

On Sat, May 28, 2022 at 12:38:11PM +0100, Marc Zyngier wrote:
> On each vcpu load, we set the KVM_ARM64_HOST_SVE_ENABLED
> flag if SVE is enabled for EL0 on the host. This is used to restore
> the correct state on vpcu put.
> 
> However, it appears that nothing ever clears this flag. Once
> set, it will stick until the vcpu is destroyed, which has the
> potential to spuriously enable SVE for userspace.

Oh dear.

Reviewed-by: Mark Brown <broonie at kernel.org>

> We probably never saw the issue because no VMM uses SVE, but
> that's still pretty bad. Unconditionally clearing the flag
> on vcpu load addresses the issue.

Unless I'm missing something since we currently always disable
SVE on syscall even if the VMM were using SVE for some reason
(SVE memcpy()?) we should already have disabled SVE for EL0 in
sve_user_discard() during kernel entry so EL0 access to SVE
should be disabled in the system register by the time we get
here.
-------------- next part --------------
A non-text attachment was scrubbed...
Name: signature.asc
Type: application/pgp-signature
Size: 488 bytes
Desc: not available
URL: <http://lists.infradead.org/pipermail/linux-arm-kernel/attachments/20220530/ff0bf47f/attachment.sig>