[PATCH] perf mem: Trace physical address for Arm SPE events

[Leo Yan]

Currently, Arm SPE events don't trace physical address, therefore, the
field 'phys_addr' is always zero in synthesized memory samples.  This
leads to perf c2c tool cannot locate the memory node for samples.

This patch enables configuration 'pa_enable' for Arm SPE events, so the
physical address packet can be traced, finally this can allow perf c2c
tool to locate properly for memory node.

Signed-off-by: Leo Yan <leo.yan at linaro.org>
---
 tools/perf/arch/arm64/util/mem-events.c | 6 +++---
 1 file changed, 3 insertions(+), 3 deletions(-)

diff --git a/tools/perf/arch/arm64/util/mem-events.c b/tools/perf/arch/arm64/util/mem-events.c
index be41721b9aa1..df817d1f9f3e 100644
--- a/tools/perf/arch/arm64/util/mem-events.c
+++ b/tools/perf/arch/arm64/util/mem-events.c
@@ -5,9 +5,9 @@
 #define E(t, n, s) { .tag = t, .name = n, .sysfs_name = s }
 
 static struct perf_mem_event perf_mem_events[PERF_MEM_EVENTS__MAX] = {
-	E("spe-load",	"arm_spe_0/ts_enable=1,load_filter=1,store_filter=0,min_latency=%u/",	"arm_spe_0"),
-	E("spe-store",	"arm_spe_0/ts_enable=1,load_filter=0,store_filter=1/",			"arm_spe_0"),
-	E("spe-ldst",	"arm_spe_0/ts_enable=1,load_filter=1,store_filter=1,min_latency=%u/",	"arm_spe_0"),
+	E("spe-load",	"arm_spe_0/ts_enable=1,pa_enable=1,load_filter=1,store_filter=0,min_latency=%u/",	"arm_spe_0"),
+	E("spe-store",	"arm_spe_0/ts_enable=1,pa_enable=1,load_filter=0,store_filter=1/",			"arm_spe_0"),
+	E("spe-ldst",	"arm_spe_0/ts_enable=1,pa_enable=1,load_filter=1,store_filter=1,min_latency=%u/",	"arm_spe_0"),
 };
 
 static char mem_ev_name[100];
-- 
2.25.1