[PATCH] ARM: configs: enable support for Kontron KSwitch D10

[Nicolas Ferre]

Arnd, Michael,

On 18/05/2022 at 16:52, Arnd Bergmann wrote:
> On Wed, May 18, 2022 at 3:15 PM Michael Walle <michael at walle.cc> wrote:
>>
>> The Kontron KSwitch D10 is based on a Microchip LAN9668 SoC. It is a
>> managed ethernet network switch with either 8 copper ports or 6 copper
>> ports and 2 SFP cages.
>>
>> Enable all required kconfig symbols, either as module where possible or
>> compiled-in where it is not possible.
>>
>> Signed-off-by: Michael Walle <michael at walle.cc>

Acked-by: Nicolas Ferre <nicolas.ferre at microchip.com>

>> ---
>> FWIW, there will be a board in our lab in KernelCI using this config.
> 
> The patch looks ok to me, but normally I'd expect it to go through the
> platform maintainer tree unless there is a reason not to. Adding the at91
> maintainers to Cc here.
> 
> It's also a bit late for 5.19, but if everyone agrees, I can add the patch
> to the arm/late branch.

If it's possible for you Arnd, I do agree that you take it in the 
arm/late branch.

Thanks, best regards,
   Nicolas

-- 
Nicolas Ferre