[PATCH] ARM: configs: enable support for Kontron KSwitch D10

[Michael Walle]

The Kontron KSwitch D10 is based on a Microchip LAN9668 SoC. It is a
managed ethernet network switch with either 8 copper ports or 6 copper
ports and 2 SFP cages.

Enable all required kconfig symbols, either as module where possible or
compiled-in where it is not possible.

Signed-off-by: Michael Walle <michael at walle.cc>
---
FWIW, there will be a board in our lab in KernelCI using this config.

 arch/arm/configs/multi_v7_defconfig | 11 +++++++++++
 1 file changed, 11 insertions(+)

diff --git a/arch/arm/configs/multi_v7_defconfig b/arch/arm/configs/multi_v7_defconfig
index 547918170f1f..a858ba971340 100644
--- a/arch/arm/configs/multi_v7_defconfig
+++ b/arch/arm/configs/multi_v7_defconfig
@@ -17,6 +17,7 @@ CONFIG_SOC_SAMA5D2=y
 CONFIG_SOC_SAMA5D3=y
 CONFIG_SOC_SAMA5D4=y
 CONFIG_SOC_SAMA7G5=y
+CONFIG_SOC_LAN966=y
 CONFIG_ARCH_BCM=y
 CONFIG_ARCH_BCM_CYGNUS=y
 CONFIG_ARCH_BCM_HR2=y
@@ -277,6 +278,7 @@ CONFIG_MV643XX_ETH=y
 CONFIG_MVNETA=y
 CONFIG_PXA168_ETH=m
 CONFIG_KS8851=y
+CONFIG_LAN966X_SWITCH=m
 CONFIG_R8169=y
 CONFIG_SH_ETH=y
 CONFIG_SMSC911X=y
@@ -287,6 +289,7 @@ CONFIG_TI_CPSW=y
 CONFIG_TI_CPSW_SWITCHDEV=y
 CONFIG_TI_CPTS=y
 CONFIG_XILINX_EMACLITE=y
+CONFIG_SFP=m
 CONFIG_BROADCOM_PHY=y
 CONFIG_ICPLUS_PHY=y
 CONFIG_MARVELL_PHY=y
@@ -294,6 +297,7 @@ CONFIG_AT803X_PHY=y
 CONFIG_ROCKCHIP_PHY=y
 CONFIG_DP83867_PHY=y
 CONFIG_USB_BRCMSTB=m
+CONFIG_MDIO_MSCC_MIIM=m
 CONFIG_USB_PEGASUS=y
 CONFIG_USB_RTL8152=m
 CONFIG_USB_LAN78XX=m
@@ -430,6 +434,7 @@ CONFIG_I2C_CROS_EC_TUNNEL=m
 CONFIG_I2C_SLAVE_EEPROM=y
 CONFIG_SPI=y
 CONFIG_SPI_ATMEL=m
+CONFIG_SPI_ATMEL_QUADSPI=m
 CONFIG_SPI_BCM2835=y
 CONFIG_SPI_BCM2835AUX=y
 CONFIG_SPI_CADENCE=y
@@ -459,6 +464,8 @@ CONFIG_SPMI=y
 CONFIG_PTP_1588_CLOCK=y
 CONFIG_PINCTRL_AS3722=y
 CONFIG_PINCTRL_STMFX=y
+CONFIG_PINCTRL_MICROCHIP_SGPIO=y
+CONFIG_PINCTRL_OCELOT=y
 CONFIG_PINCTRL_PALMAS=y
 CONFIG_PINCTRL_OWL=y
 CONFIG_PINCTRL_S500=y
@@ -517,6 +524,7 @@ CONFIG_CHARGER_TPS65090=y
 CONFIG_SENSORS_ARM_SCMI=y
 CONFIG_SENSORS_ASPEED=m
 CONFIG_SENSORS_IIO_HWMON=y
+CONFIG_SENSORS_LAN966X=m
 CONFIG_SENSORS_LM90=y
 CONFIG_SENSORS_LM95245=y
 CONFIG_SENSORS_NTC_THERMISTOR=m
@@ -1018,6 +1026,7 @@ CONFIG_CROS_EC_SPI=m
 CONFIG_COMMON_CLK_MAX77686=y
 CONFIG_COMMON_CLK_RK808=m
 CONFIG_COMMON_CLK_SCMI=y
+CONFIG_COMMON_CLK_LAN966X=y
 CONFIG_COMMON_CLK_S2MPS11=m
 CONFIG_CLK_RASPBERRYPI=y
 CONFIG_COMMON_CLK_QCOM=y
@@ -1145,6 +1154,7 @@ CONFIG_PWM_SUN4I=y
 CONFIG_PWM_TEGRA=y
 CONFIG_PWM_VT8500=y
 CONFIG_KEYSTONE_IRQ=y
+CONFIG_RESET_MCHP_SPARX5=y
 CONFIG_PHY_SUN4I_USB=y
 CONFIG_PHY_SUN9I_USB=y
 CONFIG_PHY_HIX5HD2_SATA=y
@@ -1152,6 +1162,7 @@ CONFIG_PHY_BERLIN_SATA=y
 CONFIG_PHY_BERLIN_USB=y
 CONFIG_PHY_BRCM_USB=m
 CONFIG_PHY_MMP3_USB=m
+CONFIG_PHY_LAN966X_SERDES=m
 CONFIG_PHY_CPCAP_USB=m
 CONFIG_PHY_QCOM_APQ8064_SATA=m
 CONFIG_PHY_QCOM_USB_HS=y
-- 
2.30.2