[PATCH v2 2/3] ARM: dts: aspeed: Add USB2.0 device controller node
Krzysztof Kozlowski
krzysztof.kozlowski at linaro.org
Tue May 17 07:53:33 PDT 2022
On 17/05/2022 16:50, Neal Liu wrote:
>> -----Original Message-----
>> From: Krzysztof Kozlowski <krzysztof.kozlowski at linaro.org>
>> Sent: Tuesday, May 17, 2022 8:00 PM
>> To: Neal Liu <neal_liu at aspeedtech.com>; Greg Kroah-Hartman
>> <gregkh at linuxfoundation.org>; Rob Herring <robh+dt at kernel.org>; Krzysztof
>> Kozlowski <krzysztof.kozlowski+dt at linaro.org>; Joel Stanley <joel at jms.id.au>;
>> Andrew Jeffery <andrew at aj.id.au>; Felipe Balbi <balbi at kernel.org>; Sumit
>> Semwal <sumit.semwal at linaro.org>; Christian König
>> <christian.koenig at amd.com>; Geert Uytterhoeven <geert at linux-m68k.org>;
>> Li Yang <leoyang.li at nxp.com>
>> Cc: linux-aspeed at lists.ozlabs.org; linux-usb at vger.kernel.org;
>> devicetree at vger.kernel.org; linux-arm-kernel at lists.infradead.org;
>> linux-kernel at vger.kernel.org; linux-media at vger.kernel.org;
>> dri-devel at lists.freedesktop.org; linaro-mm-sig at lists.linaro.org
>> Subject: Re: [PATCH v2 2/3] ARM: dts: aspeed: Add USB2.0 device controller
>> node
>>
>> On 17/05/2022 10:25, Neal Liu wrote:
>>> Add USB2.0 device controller(udc) node to device tree for AST2600.
>>>
>>> Signed-off-by: Neal Liu <neal_liu at aspeedtech.com>
>>> ---
>>> arch/arm/boot/dts/aspeed-g6.dtsi | 10 ++++++++++
>>> 1 file changed, 10 insertions(+)
>>>
>>> diff --git a/arch/arm/boot/dts/aspeed-g6.dtsi
>>> b/arch/arm/boot/dts/aspeed-g6.dtsi
>>> index 3d5ce9da42c3..5517313eb2b5 100644
>>> --- a/arch/arm/boot/dts/aspeed-g6.dtsi
>>> +++ b/arch/arm/boot/dts/aspeed-g6.dtsi
>>> @@ -298,6 +298,16 @@ vhub: usb-vhub at 1e6a0000 {
>>> status = "disabled";
>>> };
>>>
>>> + udc: udc at 1e6a2000 {
>>
>> The same as DTS in bindings - generic node name, please.
>>
>
> Is it possible to use "udc: usb-udc at 1e6a2000" to distinguish it between "vhub: usb-vhub at 1e6a0000"?
Possible yes :), but not recommended and not wanted. Nodes should be
generic and prefixes are added only if there is no unit address. You can
though use some more descriptive label.
Best regards,
Krzysztof
More information about the linux-arm-kernel
mailing list