[PATCH v2 3/3] ARM: dts: stm32: add STM32MP1-based Phytec board

[Alexandre TORGUE]

Hi Steffen


On 5/16/22 14:16, Steffen Trumtrar wrote:
> Add the Phytec STM32MP1-3 Dev board. The devboard uses a Phytec stm32m15-som.
> 
> Signed-off-by: Steffen Trumtrar <s.trumtrar at pengutronix.de>
> ---
>   .../dts/stm32mp157c-phycore-stm32mp1-3.dts    | 56 +++++++++++++++++++
>   1 file changed, 56 insertions(+)
>   create mode 100644 arch/arm/boot/dts/stm32mp157c-phycore-stm32mp1-3.dts
> 
> diff --git a/arch/arm/boot/dts/stm32mp157c-phycore-stm32mp1-3.dts b/arch/arm/boot/dts/stm32mp157c-phycore-stm32mp1-3.dts
> new file mode 100644
> index 000000000000..e91c0ef499c9
> --- /dev/null
> +++ b/arch/arm/boot/dts/stm32mp157c-phycore-stm32mp1-3.dts
> @@ -0,0 +1,56 @@
> +// SPDX-License-Identifier: (GPL-2.0+ OR BSD-3-Clause)
> +/*
> + * Copyright (C) Phytec GmbH 2019-2020 - All Rights Reserved
> + * Author: Dom VOVARD <dom.vovard at linrt.com>.
> + */
> +
> +/dts-v1/;
> +
> +#include <dt-bindings/pinctrl/stm32-pinfunc.h>
> +#include "stm32mp157.dtsi"
> +#include "stm32mp15xc.dtsi"
> +#include "stm32mp15xxac-pinctrl.dtsi"
> +#include "stm32mp157c-phycore-stm32mp15-som.dtsi"
> +
> +/ {
> +	model = "PHYTEC phyCORE-STM32MP1-3 Dev Board";
> +	compatible = "phytec,phycore-stm32mp1-3", "st,stm32mp157";

You must define this board in yaml file. I can't take it as yaml 
verification is not satisfied.

> +};
> +
> +&cryp1 {
> +	status = "okay";
> +};
> +
> +&dts {
> +	status = "okay";
> +};
> +
> +&fmc {
> +	status = "disabled";
> +};
> +
> +&gpu {
> +	status = "okay";
> +	contiguous-area = <&gpu_reserved>;
> +};
> +
> +&i2c4_eeprom {
> +	status = "okay";
> +};
> +
> +&i2c4_rtc {
> +	status = "okay";
> +};
> +
> +&qspi {
> +	status = "okay";
> +};
> +
> +&sdmmc1 {
> +	secure-status = "disabled";
> +};
> +
> +&sdmmc2 {
> +	status = "okay";
> +	secure-status = "disabled";
> +};