[PATCH v4 2/2] ARM: dts: sun8i-r40: add opp table for cpu

[Maxime Ripard]

On Mon, May 16, 2022 at 10:15:16AM +0800, qianfanguijin at 163.com wrote:
> From: qianfan Zhao <qianfanguijin at 163.com>
> 
> OPP table value is get from allwinner lichee linux-3.10 kernel driver
> 
> Signed-off-by: qianfan Zhao <qianfanguijin at 163.com>
> ---
>  arch/arm/boot/dts/sun8i-r40.dtsi | 42 ++++++++++++++++++++++++++++++++
>  1 file changed, 42 insertions(+)
> 
> diff --git a/arch/arm/boot/dts/sun8i-r40.dtsi b/arch/arm/boot/dts/sun8i-r40.dtsi
> index 291f4784e86c..8949153eb0eb 100644
> --- a/arch/arm/boot/dts/sun8i-r40.dtsi
> +++ b/arch/arm/boot/dts/sun8i-r40.dtsi
> @@ -54,6 +54,36 @@ / {
>  	#size-cells = <1>;
>  	interrupt-parent = <&gic>;
>  
> +	cpu0_opp_table: opp_table0 {
> +		compatible = "operating-points-v2";
> +		opp-shared;
> +
> +		opp-720000000 {
> +			opp-hz = /bits/ 64 <720000000>;
> +			opp-microvolt = <1000000 1000000 1300000>;
> +			clock-latency-ns = <2000000>;
> +		};
> +
> +		opp-912000000 {
> +			opp-hz = /bits/ 64 <912000000>;
> +			opp-microvolt = <1100000 1100000 1300000>;
> +			clock-latency-ns = <2000000>;
> +		};
> +
> +		opp-1008000000 {
> +			opp-hz = /bits/ 64 <1008000000>;
> +			opp-microvolt = <1160000 1160000 1300000>;
> +			clock-latency-ns = <2000000>;
> +		};
> +
> +		/* The opp table of the cpu frequency that exceeds 1G
> +		 * is not defined here. They require higher operating
> +		 * current, which may exceed the 500mA limited if the
> +		 * system is powered by USB. You can add them to the
> +		 * board's DTS is you make sure.
> +		 */

That's not the issue though. The issue is that the board is setup with a
CPU voltage at 1160mV, and if we raise the frequency to a higher OPP
without raising the voltage as well, the CPU will crash.

Maxime