[PATCH v3 08/11] arm64: dts: marvell: rename temp sensor nodes

[Robert Marko]

Rename the temperature sensor nodes to use "temp-sensor" which matches
their device class instead of IC specific naming.

Remove the status = "okay" which is not required as its default anyway.

Signed-off-by: Robert Marko <robert.marko at sartura.hr>
---
 arch/arm64/boot/dts/marvell/armada-3720-uDPU.dts | 6 ++----
 1 file changed, 2 insertions(+), 4 deletions(-)

diff --git a/arch/arm64/boot/dts/marvell/armada-3720-uDPU.dts b/arch/arm64/boot/dts/marvell/armada-3720-uDPU.dts
index b89c7455612d..f21a855fc608 100644
--- a/arch/arm64/boot/dts/marvell/armada-3720-uDPU.dts
+++ b/arch/arm64/boot/dts/marvell/armada-3720-uDPU.dts
@@ -152,14 +152,12 @@ &i2c1 {
 	scl-gpios = <&gpionb 2 (GPIO_ACTIVE_HIGH | GPIO_OPEN_DRAIN)>;
 	sda-gpios = <&gpionb 3 (GPIO_ACTIVE_HIGH | GPIO_OPEN_DRAIN)>;
 
-	nct375 at 48 {
-		status = "okay";
+	temp-sensor at 48 {
 		compatible = "ti,tmp75c";
 		reg = <0x48>;
 	};
 
-	nct375 at 49 {
-		status = "okay";
+	temp-sensor at 49 {
 		compatible = "ti,tmp75c";
 		reg = <0x49>;
 	};
-- 
2.36.1