[RFC v8 net-next 05/16] pinctrl: ocelot: add ability to be used in a non-mmio configuration
Colin Foster
colin.foster at in-advantage.com
Sun May 8 11:53:02 PDT 2022
There are a few Ocelot chips that contain pinctrl logic, but can be
controlled externally. Specifically the VSC7511, 7512, 7513 and 7514. In
the externally controlled configurations these registers are not
memory-mapped.
Add support for these non-memory-mapped configurations.
Signed-off-by: Colin Foster <colin.foster at in-advantage.com>
---
drivers/pinctrl/pinctrl-ocelot.c | 31 ++++++++++++++++++++++++-------
1 file changed, 24 insertions(+), 7 deletions(-)
diff --git a/drivers/pinctrl/pinctrl-ocelot.c b/drivers/pinctrl/pinctrl-ocelot.c
index 30577fedb7fc..4995c90019c5 100644
--- a/drivers/pinctrl/pinctrl-ocelot.c
+++ b/drivers/pinctrl/pinctrl-ocelot.c
@@ -20,6 +20,7 @@
#include <linux/platform_device.h>
#include <linux/regmap.h>
#include <linux/slab.h>
+#include <soc/mscc/ocelot.h>
#include "core.h"
#include "pinconf.h"
@@ -1215,6 +1216,9 @@ static int lan966x_pinmux_set_mux(struct pinctrl_dev *pctldev,
return 0;
}
+#if defined(REG)
+#undef REG
+#endif
#define REG(r, info, p) ((r) * (info)->stride + (4 * ((p) / 32)))
static int ocelot_gpio_set_direction(struct pinctrl_dev *pctldev,
@@ -1908,6 +1912,7 @@ static int ocelot_pinctrl_probe(struct platform_device *pdev)
struct device *dev = &pdev->dev;
struct ocelot_pinctrl *info;
struct regmap *pincfg;
+ struct resource *res;
void __iomem *base;
int ret;
struct regmap_config regmap_config = {
@@ -1922,16 +1927,28 @@ static int ocelot_pinctrl_probe(struct platform_device *pdev)
info->desc = (struct pinctrl_desc *)device_get_match_data(dev);
- base = devm_ioremap_resource(dev,
- platform_get_resource(pdev, IORESOURCE_MEM, 0));
- if (IS_ERR(base))
- return PTR_ERR(base);
+ base = devm_platform_get_and_ioremap_resource(pdev, 0, NULL);
+ if (IS_ERR(base)) {
+ /*
+ * Fall back to using IORESOURCE_REG, which is possible in an
+ * MFD configuration
+ */
+ res = platform_get_resource(pdev, IORESOURCE_REG, 0);
+ if (!res) {
+ dev_err(dev, "Failed to get resource\n");
+ return -ENODEV;
+ }
- info->stride = 1 + (info->desc->npins - 1) / 32;
+ info->map = ocelot_init_regmap_from_resource(dev, res);
+ } else {
+ regmap_config.max_register =
+ OCELOT_GPIO_SD_MAP * info->stride + 15 * 4;
- regmap_config.max_register = OCELOT_GPIO_SD_MAP * info->stride + 15 * 4;
+ info->map = devm_regmap_init_mmio(dev, base, ®map_config);
+ }
+
+ info->stride = 1 + (info->desc->npins - 1) / 32;
- info->map = devm_regmap_init_mmio(dev, base, ®map_config);
if (IS_ERR(info->map)) {
dev_err(dev, "Failed to create regmap\n");
return PTR_ERR(info->map);
--
2.25.1
More information about the linux-arm-kernel
mailing list