[PATCH 07/22] firmware: arm_scmi: Check CLOCK_RATE_SET_COMPLETE async reply

[Cristian Marussi]

When CLOCK_RATE_SET command is issued in asynchronous mode the delayed
response CLOCK_RATE_SET_COMPLETE comes back once the SCMI platform has
effectively operated the requested change: such delayed response carries
also the clock ID and the final clock rate that has been set.

As an aid to debug issues, check that the clock ID in the delayed
response matches the expected one and debug print the rate value.

Signed-off-by: Cristian Marussi <cristian.marussi at arm.com>
---
 drivers/firmware/arm_scmi/clock.c | 23 +++++++++++++++++++++--
 1 file changed, 21 insertions(+), 2 deletions(-)

diff --git a/drivers/firmware/arm_scmi/clock.c b/drivers/firmware/arm_scmi/clock.c
index 0ae39ee920e9..32ccac457d20 100644
--- a/drivers/firmware/arm_scmi/clock.c
+++ b/drivers/firmware/arm_scmi/clock.c
@@ -68,6 +68,12 @@ struct scmi_clock_set_rate {
 	__le32 value_high;
 };
 
+struct scmi_msg_resp_set_rate_complete {
+	__le32 id;
+	__le32 rate_low;
+	__le32 rate_high;
+};
+
 struct clock_info {
 	u32 version;
 	int num_clocks;
@@ -266,10 +272,23 @@ static int scmi_clock_rate_set(const struct scmi_protocol_handle *ph,
 	cfg->value_low = cpu_to_le32(rate & 0xffffffff);
 	cfg->value_high = cpu_to_le32(rate >> 32);
 
-	if (flags & CLOCK_SET_ASYNC)
+	if (flags & CLOCK_SET_ASYNC) {
 		ret = ph->xops->do_xfer_with_response(ph, t);
-	else
+		if (!ret) {
+			struct scmi_msg_resp_set_rate_complete *resp;
+
+			resp = t->rx.buf;
+			if (le32_to_cpu(resp->id) == clk_id)
+				dev_dbg(ph->dev,
+					"Clock ID %d set async to %llu\n",
+					clk_id,
+					get_unaligned_le64(&resp->rate_low));
+			else
+				ret = -EPROTO;
+		}
+	} else {
 		ret = ph->xops->do_xfer(ph, t);
+	}
 
 	if (ci->max_async_req)
 		atomic_dec(&ci->cur_async_req);
-- 
2.32.0