[PATCH] ARM: dts: imx6qdl-apalis: Fix sgtl5000 detection issue

[Fabio Estevam]

On a custom carrier board with a i.MX6Q Apalis SoM, the sgtl5000 codec
on the SoM is often not detected and the following error message is
seen when the sgtl5000 driver tries to read the ID register:

sgtl5000 1-000a: Error reading chip id -6

The reason for the error is that the MCLK clock is not provided
early enough.

Fix the problem by describing the MCLK pinctrl inside the codec
node instead of placing it inside the audmux pinctrl group.

With this change applied the sgtl5000 is always detected on every boot.

Fixes: 693e3ffaae5a ("ARM: dts: imx6: Add support for Toradex Apalis iMX6Q/D SoM")
Signed-off-by: Fabio Estevam <festevam at gmail.com>
---
 arch/arm/boot/dts/imx6qdl-apalis.dtsi | 10 ++++++++--
 1 file changed, 8 insertions(+), 2 deletions(-)

diff --git a/arch/arm/boot/dts/imx6qdl-apalis.dtsi b/arch/arm/boot/dts/imx6qdl-apalis.dtsi
index ed2739e39085..bd763bae596b 100644
--- a/arch/arm/boot/dts/imx6qdl-apalis.dtsi
+++ b/arch/arm/boot/dts/imx6qdl-apalis.dtsi
@@ -286,6 +286,8 @@ vgen6_reg: vgen6 {
 	codec: sgtl5000 at a {
 		compatible = "fsl,sgtl5000";
 		reg = <0x0a>;
+		pinctrl-names = "default";
+		pinctrl-0 = <&pinctrl_sgtl5000>;
 		clocks = <&clks IMX6QDL_CLK_CKO>;
 		VDDA-supply = <&reg_module_3v3_audio>;
 		VDDIO-supply = <&reg_module_3v3>;
@@ -517,8 +519,6 @@ MX6QDL_PAD_DISP0_DAT20__AUD4_TXC	0x130b0
 			MX6QDL_PAD_DISP0_DAT21__AUD4_TXD	0x130b0
 			MX6QDL_PAD_DISP0_DAT22__AUD4_TXFS	0x130b0
 			MX6QDL_PAD_DISP0_DAT23__AUD4_RXD	0x130b0
-			/* SGTL5000 sys_mclk */
-			MX6QDL_PAD_GPIO_5__CCM_CLKO1		0x130b0
 		>;
 	};
 
@@ -811,6 +811,12 @@ MX6QDL_PAD_NANDF_CS1__GPIO6_IO14 0x000b0
 		>;
 	};
 
+	pinctrl_sgtl5000: sgtl5000grp {
+		fsl,pins = <
+			MX6QDL_PAD_GPIO_5__CCM_CLKO1	0x130b0
+		>;
+	};
+
 	pinctrl_spdif: spdifgrp {
 		fsl,pins = <
 			MX6QDL_PAD_GPIO_16__SPDIF_IN  0x1b0b0
-- 
2.25.1