[PATCH v6 11/25] KVM: arm64: Add remaining ID registers to id_reg_desc_table

[Oliver Upton]

On Wed, Mar 23, 2022 at 01:13:32PM -0700, Ricardo Koller wrote:
> On Wed, Mar 23, 2022 at 07:53:14PM +0000, Oliver Upton wrote:
> > Hi Reiji,
> > 
> > On Thu, Mar 10, 2022 at 08:47:57PM -0800, Reiji Watanabe wrote:
> > > Add hidden or reserved ID registers, and remaining ID registers,
> > > which don't require special handling, to id_reg_desc_table.
> > > Add 'flags' field to id_reg_desc, which is used to indicates hiddden
> > > or reserved registers. Since now id_reg_desc_init() is called even
> > > for hidden/reserved registers, change it to not do anything for them.
> > > 
> > > Signed-off-by: Reiji Watanabe <reijiw at google.com>
> > 
> > I think there is a very important detail of the series that probably
> > should be highlighted. We are only allowing AArch64 feature registers to
> > be configurable, right? AArch32 feature registers remain visible with
> > their default values passed through to the guest. If you've already
> > stated this as a precondition elsewhere then my apologies for the noise.
> 
> Aren't AArch64 ID regs architecturally mapped to their AArch32
> counterparts?  They should show the same values.  I'm not sure if it's a
> problem (and if KVM is faithful to that rule),

I believe it's a bit more subtle than that. The AArch32 feature registers
are architecturally mapped to certain encodings accessible from AArch64.
For example, ID_PFR0_EL1 is actually a 64 bit register where bits [31:0]
map to the ID_PFR0 AArch32 register. ID_PFR0_EL1 is only accessible from
AArch64 with the MRS instruction, and ID_PFR0 is only accessible from
AArch32 with the MRC instruction. KVM just so happens to handle both of
these reads from the same sys_reg_desc.

AFAIK, there does not exist a direct bit mapping between the
ID_*_EL1 <-> ID_AA64*_EL1 registers. But hey, could be wrong :)

--
Thanks,
Oliver