[RFC PATCH 1/1] pinctrl: imx: Reduce printk message level for empty nodes

[Linus Walleij]

On Thu, Feb 24, 2022 at 10:42 AM Alexander Stein
<alexander.stein at ew.tq-group.com> wrote:

> iomuxc_snvs from imx6ull supports 2 boot mode and 10 tamper pins.
> Probably most users won't use them, causing this error message during boot:
>   no groups defined in /soc/bus at 2200000/iomuxc-snvs at 2290000
> This is actually not an error in this case, so reduce the level
> accordingly.
>
> Signed-off-by: Alexander Stein <alexander.stein at ew.tq-group.com>
> ---
> This issue was raised during release test: Why is there an error if
> nothing is wrong?
> Memory only devices are enabled by default, which I agree, but this
> causes the mentioned error message unconditionally, unless some muxing is
> configured. I would argue that even a warning is not correct either,
> nothing is wrong here.

Patch applied.

Yours,
Linus Walleij