[PATCH v1 07/14] ARM: dts: imx6dl-colibri: Command pmic to standby for poweroff

[Max Krummenacher]

The Colibri iMX6 HW doesn't allow to use the PWR_ON_REQ signal for
poweroff. Use the fsl,pmic-stby-poweroff property to command the PMIC
into a low power mode in poweroff.

Signed-off-by: Max Krummenacher <max.krummenacher at toradex.com>
---

 arch/arm/boot/dts/imx6qdl-colibri.dtsi | 5 +++++
 1 file changed, 5 insertions(+)

diff --git a/arch/arm/boot/dts/imx6qdl-colibri.dtsi b/arch/arm/boot/dts/imx6qdl-colibri.dtsi
index f6243762e918..da52a71bb6e7 100644
--- a/arch/arm/boot/dts/imx6qdl-colibri.dtsi
+++ b/arch/arm/boot/dts/imx6qdl-colibri.dtsi
@@ -138,6 +138,10 @@
 	status = "disabled";
 };
 
+&clks {
+	fsl,pmic-stby-poweroff;
+};
+
 /* Colibri SSP */
 &ecspi4 {
 	cs-gpios = <&gpio5 2 GPIO_ACTIVE_LOW>;
@@ -403,6 +407,7 @@
 
 	pmic: pfuze100 at 8 {
 		compatible = "fsl,pfuze100";
+		fsl,pmic-stby-poweroff;
 		reg = <0x08>;
 
 		regulators {
-- 
2.20.1