[PATCH v1 0/8] pinctrl: ocelot: convert to YAML format

[Michael Walle]

Convert the pinctrl ocelot binding to the new YAML format. Pin
configuration nodes should have a "-pins" postfix. But unfortunately,
there are many device trees which don't follow this. First rename
all these nodes and then convert the binding to the YAML format so
that the validation will pass.

Because there were no maintainers before and there is none in
MAINTAINERS I added Alexandre Belloni and Lars Povlsen, juding by
the commits - to the binding as maintainers. Please tell me if you
disagree.

Michael Walle (8):
  MIPS: mscc: jaguar2: fix pinctrl nodes
  MIPS: mscc: ocelot: fix MIIM1 pinctrl node name
  MIPS: mscc: ocelot: fix PHY interrupt pinctrl node name
  MIPS: mscc: ocelot: fix load/save GPIO pinctrl name
  MIPS: mscc: serval: fix pinctrl node names
  arm64: dts: sparx5: fix pinctrl node names
  ARM: dts: lan9662-pcb8291: fix pinctrl node name
  dt-bindings: pinctrl: convert ocelot-pinctrl to YAML format

 .../bindings/pinctrl/mscc,ocelot-pinctrl.txt  | 42 ---------
 .../bindings/pinctrl/mscc,ocelot-pinctrl.yaml | 94 +++++++++++++++++++
 arch/arm/boot/dts/lan966x-pcb8291.dts         |  2 +-
 .../dts/microchip/sparx5_pcb134_board.dtsi    | 26 ++---
 .../dts/microchip/sparx5_pcb135_board.dtsi    | 10 +-
 arch/mips/boot/dts/mscc/jaguar2_pcb110.dts    | 10 +-
 arch/mips/boot/dts/mscc/jaguar2_pcb111.dts    | 10 +-
 arch/mips/boot/dts/mscc/jaguar2_pcb118.dts    |  6 +-
 arch/mips/boot/dts/mscc/ocelot.dtsi           |  4 +-
 arch/mips/boot/dts/mscc/ocelot_pcb120.dts     |  6 +-
 arch/mips/boot/dts/mscc/serval_common.dtsi    | 14 +--
 11 files changed, 138 insertions(+), 86 deletions(-)
 delete mode 100644 Documentation/devicetree/bindings/pinctrl/mscc,ocelot-pinctrl.txt
 create mode 100644 Documentation/devicetree/bindings/pinctrl/mscc,ocelot-pinctrl.yaml

-- 
2.30.2