[RFC RFT PATCH 0/4] ARM: OMAP1: clock: Convert to CCF

[Janusz Krzysztofik]

The main motivation behind this series is planned resurection of OMAP1
camera driver.  Since OMAP1 clock internals have never been visible to
drivers, that driver used to use v4l2-clk to expose a pixel clock for a
sensor.  The v4l2-clk code has been recently depreciated and removed from
the media subtree, hence the need for an alternative solution.

Janusz Krzysztofik (4):
  ARM: OMAP1: clock: Remove unused code
  ARM: OMAP1: clock: Remove noop code
  ARM: OMAP1: Prepare for conversion of OMAP1 clocks to CCF
  ARM: OMAP1: clock: Convert to CCF

 arch/arm/Kconfig                 |   2 +-
 arch/arm/mach-omap1/clock.c      | 791 ++++++++++++-------------------
 arch/arm/mach-omap1/clock.h      | 191 ++------
 arch/arm/mach-omap1/clock_data.c | 491 ++++++++-----------
 arch/arm/mach-omap1/io.c         |   5 -
 arch/arm/mach-omap1/mcbsp.c      |   8 +-
 arch/arm/mach-omap1/ocpi.c       |   4 +-
 arch/arm/mach-omap1/serial.c     |   6 +-
 arch/arm/mach-omap1/time.c       |   5 +
 arch/arm/mach-omap1/timer32k.c   |   2 +-
 drivers/usb/host/ohci-omap.c     |   8 +-
 drivers/video/fbdev/omap/lcdc.c  |   6 +-
 12 files changed, 582 insertions(+), 937 deletions(-)

The series has been tested on OMAP1510 based Amstrad Delta board,
where it works best on top of two recently submitted fixes:
ARM: OMAP1: clock: Fix early UART rate issues
ARM: OMAP1: clock: Fix UART rate reporting algorithm

-- 
2.35.1