[PATCH v3 2/3] arch_topology: obtain cpu capacity using information from CPPC

[Ionela Voinescu]

Hi Yicong,

On Wednesday 09 Mar 2022 at 18:21:30 (+0800), Yicong Yang wrote:
> Hi Ionela,
> 
> On 2022/3/3 2:09, Ionela Voinescu wrote:
> > Define topology_init_cpu_capacity_cppc() to use highest performance
> > values from _CPC objects to obtain and set maximum capacity information
> > for each CPU. acpi_cppc_processor_probe() is a good point at which to
> > trigger the initialization of CPU (u-arch) capacity values, as at this
> > point the highest performance values can be obtained from each CPU's
> > _CPC objects. Architectures can therefore use this functionality
> > through arch_init_invariance_cppc().
> > 
> > The performance scale used by CPPC is a unified scale for all CPUs in
> > the system. Therefore, by obtaining the raw highest performance values
> > from the _CPC objects, and normalizing them on the [0, 1024] capacity
> > scale, used by the task scheduler, we obtain the CPU capacity of each
> > CPU.
> > 
> 
> So we're going to use highest performance rather than nominal performance,
> and I checked the discussion in v2 [1]. Maybe we should also document this
> in sched-capacity.rst that where scheduler get the capacity from on ACPI
> based system? Currently we only have DT part but after this patch it's
> also supported on ACPI based system.
> 

It's a very good point. I'll send a separate patch for this with added
information in "3.1 CPU capacity" in sched-capacity.rst. I'll send this
separate and not with the rebase that Rafael requested to avoid
confusing things.

> Out of curiosity, since we have raw capacity now on ACPI system, seems we
> are able to scale the capacity with freq_factor now? looked into
> register_cpufreq_notifier().
> 

The freq_factor is only used for DT systems where one provides
"capacity-dmips-mhz" in DT. This entry actually represents DMIPS/MHz.

So the freq_factor, set to:

per_cpu(freq_factor, cpu) = policy->cpuinfo.max_freq / 1000;

is used to obtain the performance at the maximum frequency, basically
DMIPS = (Dhrystone) million instructions per second, by multiplying this
raw value from DT with the freq_factor. After this, all these value for
each CPU type are normalized on a scale [0, 1024], resulting in what we
call CPU capacity.

For ACPI systems freq_factor will have the default value of 1 when we
call topology_normalize_cpu_scale(), as the performance value obtained
from _CPC is already representative for the highest frequency of the CPU
and not performance/Hz as we get from DT. Therefore, we are not and
should not use a freq_factor here.

Hopefully I understood your question correctly.

Thanks,
Ionela.

> [1] https://lore.kernel.org/lkml/Yh5OAsYVBWWko+CH@arm.com/
> 
> Thanks,
> Yicong