[PATCH net-next] net: stmmac: switch no PTP HW support message to info level

[Heiner Kallweit]

If HW doesn't support PTP, then it doesn't support it. This is neither
a problem nor can the user do something about it. Therefore change the
message level to info.

Signed-off-by: Heiner Kallweit <hkallweit1 at gmail.com>
---
 drivers/net/ethernet/stmicro/stmmac/stmmac_main.c | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
index cf4e077d2..c1bfd89a5 100644
--- a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
+++ b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
@@ -3275,7 +3275,7 @@ static int stmmac_hw_setup(struct net_device *dev, bool ptp_register)
 
 	ret = stmmac_init_ptp(priv);
 	if (ret == -EOPNOTSUPP)
-		netdev_warn(priv->dev, "PTP not supported by HW\n");
+		netdev_info(priv->dev, "PTP not supported by HW\n");
 	else if (ret)
 		netdev_warn(priv->dev, "PTP init failed\n");
 	else if (ptp_register)
-- 
2.35.1