[PATCH] spi: spi-zynq-qspi: Handle error for clk_enable

[Jiasheng Jiang]

As the potential failure of the clk_enable(),
it should be better to check it and return error
if fails.

Fixes: 67dca5e580f1 ("spi: spi-mem: Add support for Zynq QSPI controller")
Signed-off-by: Jiasheng Jiang <jiasheng at iscas.ac.cn>
---
 drivers/spi/spi-zynq-qspi.c | 13 +++++++++++--
 1 file changed, 11 insertions(+), 2 deletions(-)

diff --git a/drivers/spi/spi-zynq-qspi.c b/drivers/spi/spi-zynq-qspi.c
index 78f31b61a2aa..77ea6b522348 100644
--- a/drivers/spi/spi-zynq-qspi.c
+++ b/drivers/spi/spi-zynq-qspi.c
@@ -379,12 +379,21 @@ static int zynq_qspi_setup_op(struct spi_device *spi)
 {
 	struct spi_controller *ctlr = spi->master;
 	struct zynq_qspi *qspi = spi_controller_get_devdata(ctlr);
+	int ret;
 
 	if (ctlr->busy)
 		return -EBUSY;
 
-	clk_enable(qspi->refclk);
-	clk_enable(qspi->pclk);
+	ret = clk_enable(qspi->refclk);
+	if (ret)
+		return ret;
+
+	ret = clk_enable(qspi->pclk);
+	if (ret) {
+		clk_disable(qspi->refclk);
+		return ret;
+	}
+
 	zynq_qspi_write(qspi, ZYNQ_QSPI_ENABLE_OFFSET,
 			ZYNQ_QSPI_ENABLE_ENABLE_MASK);
 
-- 
2.25.1