[PATCH RFC net-next 2/6] net: dsa: mv88e6xxx: report the default interface mode for the port

[Russell King (Oracle)]

Report the maximum speed interface mode for the port, or if we don't
have that information, the hardware configured interface mode for
the port.

This allows phylink to know which interface mode CPU and DSA ports
are operating, which will be necessary when we want to select the
maximum speed for the port (required for such ports without a PHY or
fixed-link specified in firmware.)

Signed-off-by: Russell King (Oracle) <rmk+kernel at armlinux.org.uk>
---
 drivers/net/dsa/mv88e6xxx/chip.c | 9 +++++++++
 1 file changed, 9 insertions(+)

diff --git a/drivers/net/dsa/mv88e6xxx/chip.c b/drivers/net/dsa/mv88e6xxx/chip.c
index f98be98551ef..1c6b4b00d58d 100644
--- a/drivers/net/dsa/mv88e6xxx/chip.c
+++ b/drivers/net/dsa/mv88e6xxx/chip.c
@@ -823,6 +823,7 @@ static void mv88e6xxx_get_caps(struct dsa_switch *ds, int port,
 			       phy_interface_t *default_interface)
 {
 	struct mv88e6xxx_chip *chip = ds->priv;
+	u8 cmode = chip->ports[port].cmode;
 
 	chip->info->ops->phylink_get_caps(chip, port, config);
 
@@ -830,6 +831,14 @@ static void mv88e6xxx_get_caps(struct dsa_switch *ds, int port,
 	if (mv88e6xxx_phy_is_internal(ds, port))
 		__set_bit(PHY_INTERFACE_MODE_GMII,
 			  config->supported_interfaces);
+
+	if (chip->info->ops->port_max_speed_mode)
+		*default_interface = chip->info->ops->port_max_speed_mode(port);
+	else if (cmode < ARRAY_SIZE(mv88e6xxx_phy_interface_modes) &&
+		 mv88e6xxx_phy_interface_modes[cmode])
+		*default_interface = mv88e6xxx_phy_interface_modes[cmode];
+	else if (cmode == MV88E6XXX_PORT_STS_CMODE_RGMII)
+		*default_interface = PHY_INTERFACE_MODE_RGMII;
 }
 
 static void mv88e6xxx_mac_config(struct dsa_switch *ds, int port,
-- 
2.30.2