[PATCH 05/12] i2c: xiic: Use 'nmsgs' variable instead of repeated_start

[Manikanta Guntupalli]

From: Raviteja Narayanam <raviteja.narayanam at xilinx.com>

Remove the redundant repeated_start variable as it is setup at
different places, and read at only one place which can be decided
by 'nmsgs' variable alone.

Signed-off-by: Raviteja Narayanam <raviteja.narayanam at xilinx.com>
Signed-off-by: Manikanta Guntupalli <manikanta.guntupalli at xilinx.com>
---
 drivers/i2c/busses/i2c-xiic.c | 8 +-------
 1 file changed, 1 insertion(+), 7 deletions(-)

diff --git a/drivers/i2c/busses/i2c-xiic.c b/drivers/i2c/busses/i2c-xiic.c
index 9c3266ac209e..3debb44608cf 100644
--- a/drivers/i2c/busses/i2c-xiic.c
+++ b/drivers/i2c/busses/i2c-xiic.c
@@ -61,7 +61,6 @@ enum xiic_endian {
  * @state: See STATE_
  * @singlemaster: Indicates bus is single master
  * @dynamic: Mode of controller
- * @repeated_start: Repeated start operation
  * @prev_msg_tx: Previous message is Tx
  */
 struct xiic_i2c {
@@ -80,7 +79,6 @@ struct xiic_i2c {
 	enum xilinx_i2c_state state;
 	bool singlemaster;
 	bool dynamic;
-	bool repeated_start;
 	bool prev_msg_tx;
 };
 
@@ -445,7 +443,7 @@ static void xiic_std_fill_tx_fifo(struct xiic_i2c *i2c)
 
 	if (len > fifo_space)
 		len = fifo_space;
-	else if (len && !(i2c->repeated_start))
+	else if (len && !(i2c->nmsgs > 1))
 		len--;
 
 	while (len--) {
@@ -786,7 +784,6 @@ static void xiic_start_recv(struct xiic_i2c *i2c)
 		}
 		/* Check if RSTA should be set */
 		if (cr & XIIC_CR_MSMS_MASK) {
-			i2c->repeated_start = true;
 			/* Already a master, RSTA should be set */
 			xiic_setreg8(i2c, XIIC_CR_REG_OFFSET, (cr |
 					XIIC_CR_REPEATED_START_MASK) &
@@ -805,7 +802,6 @@ static void xiic_start_recv(struct xiic_i2c *i2c)
 
 		/* Write to Control Register,to start transaction in Rx mode */
 		if ((cr & XIIC_CR_MSMS_MASK) == 0) {
-			i2c->repeated_start = false;
 			xiic_setreg8(i2c, XIIC_CR_REG_OFFSET, (cr |
 					XIIC_CR_MSMS_MASK)
 					& ~(XIIC_CR_DIR_IS_TX_MASK));
@@ -879,7 +875,6 @@ static void xiic_start_send(struct xiic_i2c *i2c)
 		/* Check if RSTA should be set */
 		cr = xiic_getreg8(i2c, XIIC_CR_REG_OFFSET);
 		if (cr & XIIC_CR_MSMS_MASK) {
-			i2c->repeated_start = true;
 			/* Already a master, RSTA should be set */
 			xiic_setreg8(i2c, XIIC_CR_REG_OFFSET, (cr |
 					XIIC_CR_REPEATED_START_MASK |
@@ -895,7 +890,6 @@ static void xiic_start_send(struct xiic_i2c *i2c)
 		xiic_std_fill_tx_fifo(i2c);
 
 		if ((cr & XIIC_CR_MSMS_MASK) == 0) {
-			i2c->repeated_start = false;
 
 			/* Start Tx by writing to CR */
 			cr = xiic_getreg8(i2c, XIIC_CR_REG_OFFSET);
-- 
2.25.1