[PATCH 3/4] firmware: arm_scmi: Get detailed power scale from perf

Sudeep Holla sudeep.holla at arm.com
Wed Jun 22 08:53:22 PDT 2022


On Wed, Jun 22, 2022 at 03:58:01PM +0100, Lukasz Luba wrote:
> In SCMI v3.1 the power scale can be in micro-Watts. The upper layers, e.g.
> cpufreq and EM should handle received power values properly (upscale when
> needed). Thus, provide an interface which allows to check what is the
> scale for power values. The old interface allowed to distinguish between
> bogo-Watts and milli-Watts only (which was good for older SCMI spec).
>

Assuming you will take this as a series,

Acked-by: Sudeep Holla <sudeep.holla at arm.com>

-- 
Regards,
Sudeep



More information about the linux-arm-kernel mailing list