[PATCH 41/49] mfd: stpmic1: Enable mask_writeonly flag for irq chip

[Aidan MacDonald]

The STPMIC1 has separate set and clear registers for controlling
its interrupt masks. These are volatile registers; writing a '1'
will set or clear the corresponding mask bit, and they read as 0.

Marking the registers volatile and using the mask_writeonly flag
should reduce bus traffic by avoiding a read-modify-write on the
mask set/clear registers.

Signed-off-by: Aidan MacDonald <aidanmacdonald.0x0 at gmail.com>
---
 drivers/mfd/stpmic1.c | 3 +++
 1 file changed, 3 insertions(+)

diff --git a/drivers/mfd/stpmic1.c b/drivers/mfd/stpmic1.c
index 11f3d92acbc0..a99f7b45df57 100644
--- a/drivers/mfd/stpmic1.c
+++ b/drivers/mfd/stpmic1.c
@@ -42,6 +42,8 @@ static const struct regmap_range stpmic1_volatile_ranges[] = {
 	regmap_reg_range(WCHDG_CR, WCHDG_CR),
 	regmap_reg_range(INT_PENDING_R1, INT_PENDING_R4),
 	regmap_reg_range(INT_SRC_R1, INT_SRC_R4),
+	regmap_reg_range(INT_SET_MASK_R1, INT_SET_MASK_R4),
+	regmap_reg_range(INT_CLEAR_MASK_R1, INT_CLEAR_MASK_R4),
 };
 
 static const struct regmap_access_table stpmic1_readable_table = {
@@ -110,6 +112,7 @@ static const struct regmap_irq_chip stpmic1_regmap_irq_chip = {
 	.status_base = INT_PENDING_R1,
 	.mask_base = INT_SET_MASK_R1,
 	.unmask_base = INT_CLEAR_MASK_R1,
+	.mask_writeonly = true,
 	.ack_base = INT_CLEAR_R1,
 	.num_regs = STPMIC1_PMIC_NUM_IRQ_REGS,
 	.irqs = stpmic1_irqs,
-- 
2.35.1