[PATCH 03/49] regmap-irq: Remove an unnecessary restriction on type_in_mask

[Aidan MacDonald]

Check types_supported instead of checking type_rising/falling_val
when using type_in_mask interrupts. This makes the intent clearer
and allows a type_in_mask irq to support level or edge triggers,
rather than only edge triggers. Update the comment to reflect the
new behavior.

Signed-off-by: Aidan MacDonald <aidanmacdonald.0x0 at gmail.com>
---
 drivers/base/regmap/regmap-irq.c | 19 ++++++++-----------
 1 file changed, 8 insertions(+), 11 deletions(-)

diff --git a/drivers/base/regmap/regmap-irq.c b/drivers/base/regmap/regmap-irq.c
index a6db605707b0..59cfd4000e63 100644
--- a/drivers/base/regmap/regmap-irq.c
+++ b/drivers/base/regmap/regmap-irq.c
@@ -253,22 +253,19 @@ static void regmap_irq_enable(struct irq_data *data)
 	struct regmap *map = d->map;
 	const struct regmap_irq *irq_data = irq_to_regmap_irq(d, data->hwirq);
 	unsigned int reg = irq_data->reg_offset / map->reg_stride;
-	unsigned int mask, type;
-
-	type = irq_data->type.type_falling_val | irq_data->type.type_rising_val;
+	unsigned int mask;
 
 	/*
 	 * The type_in_mask flag means that the underlying hardware uses
-	 * separate mask bits for rising and falling edge interrupts, but
-	 * we want to make them into a single virtual interrupt with
-	 * configurable edge.
+	 * separate mask bits for each interrupt trigger type, but we want
+	 * to have a single logical interrupt with a configurable type.
 	 *
-	 * If the interrupt we're enabling defines the falling or rising
-	 * masks then instead of using the regular mask bits for this
-	 * interrupt, use the value previously written to the type buffer
-	 * at the corresponding offset in regmap_irq_set_type().
+	 * If the interrupt we're enabling defines any supported types
+	 * then instead of using the regular mask bits for this interrupt,
+	 * use the value previously written to the type buffer at the
+	 * corresponding offset in regmap_irq_set_type().
 	 */
-	if (d->chip->type_in_mask && type)
+	if (d->chip->type_in_mask && irq_data->type.types_supported)
 		mask = d->type_buf[reg] & irq_data->mask;
 	else
 		mask = irq_data->mask;
-- 
2.35.1