rk3399-roc-pc does not boot

[Corentin Labbe]

Le Fri, Jun 17, 2022 at 01:43:05PM +0200, MR a écrit :
> 
> 
> Am 17. Juni 2022 11:58:03 MESZ schrieb Robin Murphy <robin.murphy at arm.com>:
> >On 2022-06-17 10:06, Corentin Labbe wrote:
> >> Hello
> >> 
> >> I try to add rk3399-roc-pc to kernelCI but this board fail to ends its boot with any kernel I try.
> >> It boot normally up to starting init but it stucks shorty after.
> >> It fail on 5.10, 5.15, 5.17, 5.18 and linux-next.
> >> When disabling CONFIG_USB, the board boots successfully.
> >> 
> >> In dmesg I see OF: graph: no port node found in /i2c at ff160000/usb-typec at 22
> >> According to Documentation/devicetree/bindings/usb/fcs,fusb302.txt, the port is mandatory.
> >> Can it be possible that the problem was that the power port being disabled ?
> >
> >Indeed, I believe the OF graph error is just a meaningless annoyance, but the general problem sounds like it's probably the same thing that's come up before:
> >
> >https://lore.kernel.org/all/0ac6bbe7-6395-526d-213c-ac58a19d8673@fivetechno.de/
> >
> >Disabling CONFIG_TYPEC_FUSB302 or blacklisting the fusb302 module should help confirm that. I have no idea if it's still an open problem, or if it's been fixed and you might just need to define the proper power role in the DT; this just triggered a memory of that older thread :)
> >
> >Robin.
> 
> Yes, the issue above is still there. I therefore use dumb 5 V, 4 A USB power supplies  that do not react on the USB-C communication.
> 
> Markus

@Markus
Could you try the diff I just send ?

Thanks