[PATCH v7 3/3] i2c: aspeed: Assert NAK when slave is busy

Quan Nguyen quan at os.amperecomputing.com
Fri Jun 17 00:08:55 PDT 2022


On 16/06/2022 19:29, Wolfram Sang wrote:
> Hi Quan,
> 
>> On the first occurrence of I2C_SLAVE_WRITE_REQUESTED, the address is already
>> received with ACK. So if slave return -EBUSY, the NAK will occur on the next
>> Rx byte (on I2C_SLAVE_WRITE_RECEIVED event).
> 
> This is exactly why I2C_SLAVE_WRITE_RECEIVED allows for an error code.
>  From the docs:
> 
> ===
> 
> * I2C_SLAVE_WRITE_RECEIVED (mandatory)
> 
>    'val': bus driver delivers received byte
> 
>    'ret': 0 if the byte should be acked, some errno if the byte should be nacked
> 
> Another I2C master has sent a byte to us which needs to be set in 'val'. If 'ret'
> is zero, the bus driver should ack this byte. If 'ret' is an errno, then the byte
> should be nacked.
> 
> ===
> 
> 'ret' is used to ACK/NACK the current byte in 'val'. That's exactly what
> you need, or? Does the aspeed driver not support acking the current
> byte?
>

It is true that aspeed driver does not support acking the current byte. 
Setting ASPEED_I2CD_M_S_RX_CMD_LAST will take effect on the next Rx byte 
as per my observation.

S-> Aw(ACK)-> RxD(ACK)-> Sr-> Ar-> TxD(ACK)-> ... -> TxD(NAK)-> P
      (1)        (2)

Currently, setting ASPEED_I2CD_M_S_RX_CMD_LAST in (1), on 
I2C_SLAVE_WRITE_REQUESTED event, will make the NAK happen in (2) and 
make the read stop.

If setting ASPEED_I2CD_M_S_RX_CMD_LAST on (2), ie: on 
I2C_SLAVE_WRITE_RECEIVED event, the read from Master is never NAK 
because there is no next Rx byte and Master is already switch to read 
from Slave.

I understands that the return of
i2c_slave_event(slave, I2C_SLAVE_WRITE_REQUESTED, &value) is always 0 as 
in Documentation/i2c/slave-interface.rst. But with this case, this is 
the way to NAK on the first byte and I'm wonder if this particular case 
would be supported somehow.

Thanks,
-- Quan



More information about the linux-arm-kernel mailing list