[PATCH] gpio: gpio-xilinx: Check return value of of_property_read_u32

[Srinivas Neeli]

In five different instances the return value of "of_property_read_u32"
API was neither captured nor checked.

Fixed it by capturing the return value and then checking for any error.

Signed-off-by: Srinivas Neeli <srinivas.neeli at xilinx.com>
Addresses-Coverity: "check_return"
---
 drivers/gpio/gpio-xilinx.c | 15 ++++++++++-----
 1 file changed, 10 insertions(+), 5 deletions(-)

diff --git a/drivers/gpio/gpio-xilinx.c b/drivers/gpio/gpio-xilinx.c
index b6d3a57e27ed..268c7b0e481d 100644
--- a/drivers/gpio/gpio-xilinx.c
+++ b/drivers/gpio/gpio-xilinx.c
@@ -570,7 +570,8 @@ static int xgpio_probe(struct platform_device *pdev)
 	platform_set_drvdata(pdev, chip);
 
 	/* First, check if the device is dual-channel */
-	of_property_read_u32(np, "xlnx,is-dual", &is_dual);
+	if (of_property_read_u32(np, "xlnx,is-dual", &is_dual))
+		is_dual = 0;
 
 	/* Setup defaults */
 	memset32(width, 0, ARRAY_SIZE(width));
@@ -578,14 +579,18 @@ static int xgpio_probe(struct platform_device *pdev)
 	memset32(dir, 0xFFFFFFFF, ARRAY_SIZE(dir));
 
 	/* Update GPIO state shadow register with default value */
-	of_property_read_u32(np, "xlnx,dout-default", &state[0]);
-	of_property_read_u32(np, "xlnx,dout-default-2", &state[1]);
+	if (of_property_read_u32(np, "xlnx,dout-default", &state[0]))
+		state[0] = 0x0;
+	if (of_property_read_u32(np, "xlnx,dout-default-2", &state[1]))
+		state[1] = 0x0;
 
 	bitmap_from_arr32(chip->state, state, 64);
 
 	/* Update GPIO direction shadow register with default value */
-	of_property_read_u32(np, "xlnx,tri-default", &dir[0]);
-	of_property_read_u32(np, "xlnx,tri-default-2", &dir[1]);
+	if (of_property_read_u32(np, "xlnx,tri-default", &dir[0]))
+		dir[0] = 0xFFFFFFFF;
+	if (of_property_read_u32(np, "xlnx,tri-default-2", &dir[1]))
+		dir[1] = 0xFFFFFFFF;
 
 	bitmap_from_arr32(chip->dir, dir, 64);
 
-- 
2.25.1