[PATCH v18 10/10] ARM: dts: Add Sunplus SP7021-Demo-V3 board device tree

[Arnd Bergmann]

 beOn Tue, Jun 14, 2022 at 10:31 AM Qin Jian <qinjian at cqplus1.com> wrote:
>
> Add the basic support for Sunplus SP7021-Demo-V3 board.
>
> Signed-off-by: Qin Jian <qinjian at cqplus1.com>
> ---
> Fix the comments from Krzysztof.

I'll wait for a final Ack from Krzysztof before applying this.


A few more details I noticed:


> +/ {
> +       compatible = "sunplus,sp7021";
> +       model = "Sunplus SP7021";
> +
> +       aliases {
> +               serial0 = &uart0;
> +               serial1 = &uart1;
> +               serial2 = &uart2;
> +               serial3 = &uart3;
> +               serial4 = &uart4;
> +       };

Some of these are disabled, presumably because they are not
actually connected on all boards. Better move the aliases to the .dts file
and only list the ports that are in fact used, using the numbering that
matches the labels on the board, not the numbers inside of the SoC

> +
> +       soc {
> +               compatible = "simple-bus";
> +               #address-cells = <1>;
> +               #size-cells = <1>;
> +               ranges;
> +               interrupt-parent = <&intc>;
> +
> +               intc: interrupt-controller at 9c000780 {
> +                       compatible = "sunplus,sp7021-intc";
> +                       reg = <0x9c000780 0x80>, <0x9c000a80 0x80>;
> +                       interrupt-controller;
> +                       #interrupt-cells = <2>;
> +               };

All child nodes below /soc have registers in the 0x9c000000 range. I would
suggest you use a matching 'ranges' property to translate these into a
zero-based
address like

/soc {
       ranges = <0 0x9c000000 0x10000>;

      interrupt-controller at 780 {
             reg = <0x780 0x80>, <0xa80 0x80>;
             ...
      };
};

> +               clkc: clock-controller at 9c000004 {
> +                       compatible = "sunplus,sp7021-clkc";
> +                       reg = <0x9c000004 0x28>,
> +                             <0x9c000200 0x44>,
> +                             <0x9c000268 0x04>;
> +                       clocks = <&extclk>;
> +                       #clock-cells = <1>;
> +               };
> +
> +               rstc: reset at 9c000054 {
> +                       compatible = "sunplus,sp7021-reset";
> +                       reg = <0x9c000054 0x28>;
> +                       #reset-cells = <1>;
> +               };


Maybe sort the nodes by address, or possibly by name.

       Arnd