[PATCH v11 7/8] PCI: imx6: Reduce resume time by only starting link if it was up before suspend

[Richard Zhu]

Because i.MX PCIe doesn't support hot-plug feature.
In the link down scenario, only start the PCIe link training in resume
when the link is up before system suspend to avoid the long latency in
the link training period.

Signed-off-by: Richard Zhu <hongxing.zhu at nxp.com>
---
 drivers/pci/controller/dwc/pci-imx6.c | 8 ++++----
 1 file changed, 4 insertions(+), 4 deletions(-)

diff --git a/drivers/pci/controller/dwc/pci-imx6.c b/drivers/pci/controller/dwc/pci-imx6.c
index 68d0bd703bbd..6a55bc395a2c 100644
--- a/drivers/pci/controller/dwc/pci-imx6.c
+++ b/drivers/pci/controller/dwc/pci-imx6.c
@@ -67,6 +67,7 @@ struct imx6_pcie {
 	struct dw_pcie		*pci;
 	int			reset_gpio;
 	bool			gpio_active_high;
+	bool			link_is_up;
 	struct clk		*pcie_bus;
 	struct clk		*pcie_phy;
 	struct clk		*pcie_inbound_axi;
@@ -895,6 +896,7 @@ static int imx6_pcie_start_link(struct dw_pcie *pci)
 		dev_info(dev, "Link: Gen2 disabled\n");
 	}
 
+	imx6_pcie->link_is_up = true;
 	tmp = dw_pcie_readw_dbi(pci, offset + PCI_EXP_LNKSTA);
 	dev_info(dev, "Link up, Gen%i\n", tmp & PCI_EXP_LNKSTA_CLS);
 	return 0;
@@ -1031,10 +1033,8 @@ static int imx6_pcie_resume_noirq(struct device *dev)
 	imx6_pcie_init_phy(imx6_pcie);
 	imx6_pcie_deassert_core_reset(imx6_pcie);
 	dw_pcie_setup_rc(pp);
-
-	ret = imx6_pcie_start_link(imx6_pcie->pci);
-	if (ret < 0)
-		dev_info(dev, "pcie link is down after resume.\n");
+	if (imx6_pcie->link_is_up)
+		imx6_pcie_start_link(imx6_pcie->pci);
 
 	return 0;
 }
-- 
2.25.1