[PATCH v9 0/3] arm64: mvebu: Support for Marvell 98DX2530 (and variants)

[Vadym Kochan]

This series adds support for the Marvell 98DX2530 SoC which is the Control and
Management CPU integrated into the AlleyCat5/AlleyCat5X series of Marvell
switches.

The CPU core is an ARM Cortex-A55 with neon, simd and crypto extensions.

This is fairly similar to the Armada-3700 SoC so most of the required
peripherals are already supported. This series adds a devicetree and pinctrl
driver for the SoC and the RD-AC5X-32G16HVG6HLG reference board.

The pinctrl changes from v4 have been picked up and are in linux-next so I
haven't included them in this round. That leaves just the dts files and a minor
Kconfig update for arm64.

Changes:

v9 (proposed by Marvell):
   It was discussed with Chris that Marvell will add some changes:
      1) Rename "armada-" prefix in dts(i) file names to ac5, because
         Armada has not much common with AC5 SoC.

      2) Add clock fixes:
         a) rename core_clock to cnm_clock

         b) remove axi_clock

         c) change cnm_clock to 325MHZ

         d) use cnm_clock for the UART

Chris Packham (3):
  dt-bindings: marvell: Document the AC5/AC5X compatibles
  arm64: dts: marvell: Add Armada 98DX2530 SoC and RD-AC5X board
  arm64: marvell: enable the 98DX2530 pinctrl driver

 .../bindings/arm/marvell/ac5-98dx25xx.yaml    |  32 ++
 arch/arm64/Kconfig.platforms                  |   2 +
 arch/arm64/boot/dts/marvell/Makefile          |   1 +
 arch/arm64/boot/dts/marvell/ac5-98dx25xx.dtsi | 291 ++++++++++++++++++
 .../boot/dts/marvell/ac5-98dx35xx-rd.dts      | 101 ++++++
 arch/arm64/boot/dts/marvell/ac5-98dx35xx.dtsi |  13 +
 6 files changed, 440 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/arm/marvell/ac5-98dx25xx.yaml
 create mode 100644 arch/arm64/boot/dts/marvell/ac5-98dx25xx.dtsi
 create mode 100644 arch/arm64/boot/dts/marvell/ac5-98dx35xx-rd.dts
 create mode 100644 arch/arm64/boot/dts/marvell/ac5-98dx35xx.dtsi

-- 
2.17.1