[PATCH v10 6/7] PCI: imx6: Mark the link down as none fatal error

[Bjorn Helgaas]

On Mon, Jun 13, 2022 at 04:55:37PM +0800, Richard Zhu wrote:
> let the driver probe successfully, return zero in imx6_pcie_start_link()
> when PCIe link is down.
> 
> Because i.MX PCIe doesn't support hot-plug feature.
> In this link down scenario, only start the PCIe link training in resume
> when the link is up before system suspend to avoid the long latency in
> the link training period.

This looks like two changes that should be separate patches:

  1) Make driver probe successful even if link is down.

  2) Reduce resume time by only starting the link if it was up before
     suspend.

> Signed-off-by: Richard Zhu <hongxing.zhu at nxp.com>
> ---
>  drivers/pci/controller/dwc/pci-imx6.c | 18 +++++++++++-------
>  1 file changed, 11 insertions(+), 7 deletions(-)
> 
> diff --git a/drivers/pci/controller/dwc/pci-imx6.c b/drivers/pci/controller/dwc/pci-imx6.c
> index c02748393aac..ac6ec2d691a0 100644
> --- a/drivers/pci/controller/dwc/pci-imx6.c
> +++ b/drivers/pci/controller/dwc/pci-imx6.c
> @@ -67,6 +67,7 @@ struct imx6_pcie {
>  	struct dw_pcie		*pci;
>  	int			reset_gpio;
>  	bool			gpio_active_high;
> +	bool			link_is_up;
>  	struct clk		*pcie_bus;
>  	struct clk		*pcie_phy;
>  	struct clk		*pcie_inbound_axi;
> @@ -845,7 +846,9 @@ static int imx6_pcie_start_link(struct dw_pcie *pci)
>  	/* Start LTSSM. */
>  	imx6_pcie_ltssm_enable(dev);
>  
> -	dw_pcie_wait_for_link(pci);
> +	ret = dw_pcie_wait_for_link(pci);
> +	if (ret)
> +		goto err_reset_phy;
>  
>  	if (pci->link_gen == 2) {
>  		/* Allow Gen2 mode after the link is up. */
> @@ -881,11 +884,14 @@ static int imx6_pcie_start_link(struct dw_pcie *pci)
>  		}
>  
>  		/* Make sure link training is finished as well! */
> -		dw_pcie_wait_for_link(pci);
> +		ret = dw_pcie_wait_for_link(pci);
> +		if (ret)
> +			goto err_reset_phy;
>  	} else {
>  		dev_info(dev, "Link: Gen2 disabled\n");
>  	}
>  
> +	imx6_pcie->link_is_up = true;
>  	tmp = dw_pcie_readw_dbi(pci, offset + PCI_EXP_LNKSTA);
>  	dev_info(dev, "Link up, Gen%i\n", tmp & PCI_EXP_LNKSTA_CLS);
>  	return 0;
> @@ -895,7 +901,7 @@ static int imx6_pcie_start_link(struct dw_pcie *pci)
>  		dw_pcie_readl_dbi(pci, PCIE_PORT_DEBUG0),
>  		dw_pcie_readl_dbi(pci, PCIE_PORT_DEBUG1));
>  	imx6_pcie_reset_phy(imx6_pcie);
> -	return ret;
> +	return 0;
>  }
>  
>  static int imx6_pcie_host_init(struct pcie_port *pp)
> @@ -1022,10 +1028,8 @@ static int imx6_pcie_resume_noirq(struct device *dev)
>  	imx6_pcie_init_phy(imx6_pcie);
>  	imx6_pcie_deassert_core_reset(imx6_pcie);
>  	dw_pcie_setup_rc(pp);
> -
> -	ret = imx6_pcie_start_link(imx6_pcie->pci);
> -	if (ret < 0)
> -		dev_info(dev, "pcie link is down after resume.\n");
> +	if (imx6_pcie->link_is_up)
> +		imx6_pcie_start_link(imx6_pcie->pci);
>  
>  	return 0;
>  }
> -- 
> 2.25.1
> 
> 
> _______________________________________________
> linux-arm-kernel mailing list
> linux-arm-kernel at lists.infradead.org
> http://lists.infradead.org/mailman/listinfo/linux-arm-kernel