[PATCH v7 3/3] PCI: qcom: Add IPQ60xx support

[Rob Herring]

On Sun, Jun 12, 2022 at 01:18:35PM +0300, Baruch Siach wrote:
> From: Selvam Sathappan Periakaruppan <quic_speriaka at quicinc.com>
> 
> IPQ60xx series of SoCs have one port of PCIe gen 3. Add support for that
> platform.
> 
> The code is based on downstream[1] Codeaurora kernel v5.4 (branch
> win.linuxopenwrt.2.0).
> 
> Split out the DBI registers access part from .init into .post_init. DBI
> registers are only accessible after phy_power_on().
> 
> [1] https://source.codeaurora.org/quic/qsdk/oss/kernel/linux-ipq-5.4/
> 
> Signed-off-by: Selvam Sathappan Periakaruppan <speriaka at codeaurora.org>
> Signed-off-by: Baruch Siach <baruch.siach at siklu.com>
> ---
> v7:
> 
>   * Rebase on v5.19-rc1 (Bjorn Helgaas)
> 
> v6:
> 
> Address Bjorn Helgaas comments:
> 
>   * Rename PCIE_CAP_LINK1_VAL to PCIE_CAP_SLOT_VAL
> 
>   * Drop a vague comment about ASPM configuration
> 
>   * Add a comment about the source of delay periods
> 
> v5:
> 
>   * Remove comments from qcom_pcie_init_2_9_0() (Bjorn Andersson)
> 
> v4:
> 
>   * Rebase on v5.16-rc1
> 
> v3:
>   * Drop speed setup; rely on generic code (Rob Herring)
> 
>   * Drop unused CLK_RATE macros (Bjorn Helgaas)
> 
>   * Minor formatting fixes (Bjorn Helgaas)
> 
>   * Add reference to downstream Codeaurora kernel tree (Bjorn Helgaas)
> 
> v2:
>   * Drop ATU configuration; rely on common code instead
> 
>   * Use more common register macros
> 
>   * Use bulk clk and reset APIs
> ---
>  drivers/pci/controller/dwc/pcie-designware.h |   1 +
>  drivers/pci/controller/dwc/pcie-qcom.c       | 140 +++++++++++++++++++
>  2 files changed, 141 insertions(+)

Reviewed-by: Rob Herring <robh at kernel.org>